[PATCH v5 3/5] spi: sun6i: add quirk for in-controller clock divider

Jernej Škrabec jernej.skrabec at gmail.com
Thu May 11 09:38:58 PDT 2023


Dne sreda, 10. maj 2023 ob 10:11:10 CEST je Maksim Kiselev napisal(a):
> Previously SPI controllers in Allwinner SoCs has a clock divider inside.
> However now the clock divider is removed and to set the transfer clock
> rate it's only needed to set the SPI module clock to the target value
> and configure a proper work mode.
> 
> According to the datasheet there are three work modes:
> | SPI Sample Mode         | SDM(bit13) | SDC(bit11) | Run Clock |
> |
> |-------------------------|------------|------------|-----------|
> |
> | normal sample           |      1     |      0     | <= 24 MHz |
> | delay half cycle sample |      0     |      0     | <= 40 MHz |
> | delay one cycle sample  |      0     |      1     | >= 80 MHz |
> 
> Add a quirk for this kind of SPI controllers.
> 
> Co-developed-by: Icenowy Zheng <icenowy at aosc.io>
> Signed-off-by: Maksim Kiselev <bigunclemax at gmail.com>

Reviewed-by: Jernej Skrabec <jernej.skrabec at gmail.com>

Best regards,
Jernej





More information about the linux-arm-kernel mailing list