[PATCH] arm64: dts: ti: k3-am625-beagleplay: Use UART name in pinmux name

[Robert Nelson]

Andew, since we are touching this section, do you want to match with
@Tony Lindgren rename changes here in omap...

https://www.spinics.net/lists/linux-omap/msg166406.html

Regards,

On Thu, Jun 1, 2023 at 1:56 PM Andrew Davis <afd at ti.com> wrote:
>
> The main_uart0 may not always be the console, but it will always be
> the UART0 in MAIN domain. Name the pinmux node to match. This makes
> it consistent with all other TI SoC based boards.
>
> Signed-off-by: Andrew Davis <afd at ti.com>
> ---
>  arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts b/arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts
> index cb46c38ce2cc1..29c51705c2f17 100644
> --- a/arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts
> +++ b/arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts
> @@ -397,7 +397,7 @@ AM62X_IOPAD(0x01a8, PIN_INPUT, 7) /* (D20) MCASP0_AFSX.GPIO1_12 */
>                 >;
>         };
>
> -       console_pins_default: console-pins-default {
> +       main_uart0_pins_default: main-uart0-pins-default {
>                 pinctrl-single,pins = <
>                         AM62X_IOPAD(0x01c8, PIN_INPUT, 0) /* (D14) UART0_RXD */
>                         AM62X_IOPAD(0x01cc, PIN_OUTPUT, 0) /* (E14) UART0_TXD */
> @@ -736,7 +736,7 @@ wlcore: wlcore at 2 {
>
>  &main_uart0 {
>         pinctrl-names = "default";
> -       pinctrl-0 = <&console_pins_default>;
> +       pinctrl-0 = <&main_uart0_pins_default>;
>         status = "okay";
>  };
>
> --
> 2.39.2
>


-- 
Robert Nelson
https://rcn-ee.com/