[PATCH] arm64: dts: ti: k3-am625-beagleplay: Use UART name in pinmux name

[Andrew Davis]

The main_uart0 may not always be the console, but it will always be
the UART0 in MAIN domain. Name the pinmux node to match. This makes
it consistent with all other TI SoC based boards.

Signed-off-by: Andrew Davis <afd at ti.com>
---
 arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts b/arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts
index cb46c38ce2cc1..29c51705c2f17 100644
--- a/arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts
+++ b/arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts
@@ -397,7 +397,7 @@ AM62X_IOPAD(0x01a8, PIN_INPUT, 7) /* (D20) MCASP0_AFSX.GPIO1_12 */
 		>;
 	};
 
-	console_pins_default: console-pins-default {
+	main_uart0_pins_default: main-uart0-pins-default {
 		pinctrl-single,pins = <
 			AM62X_IOPAD(0x01c8, PIN_INPUT, 0) /* (D14) UART0_RXD */
 			AM62X_IOPAD(0x01cc, PIN_OUTPUT, 0) /* (E14) UART0_TXD */
@@ -736,7 +736,7 @@ wlcore: wlcore at 2 {
 
 &main_uart0 {
 	pinctrl-names = "default";
-	pinctrl-0 = <&console_pins_default>;
+	pinctrl-0 = <&main_uart0_pins_default>;
 	status = "okay";
 };
 
-- 
2.39.2