[PATCH v3 2/4] input: bbnsm_pwrkey: Add bbnsm power key support

Jacky Bai ping.bai at nxp.com
Mon Jan 2 23:47:40 PST 2023


The ON/OFF logic inside the BBNSM allows for connecting directly
into a PMIC or other voltage regulator device. The module has an
button input signal and a wakeup request input signal. It also
has two interrupts (set_pwr_off_irq and set_pwr_on_irq) and an
active-low PMIC enable (pmic_en_b) output.

Add the power key support for the ON/OFF button function found in
BBNSM module.

Signed-off-by: Jacky Bai <ping.bai at nxp.com>
Reviewed-by: Peng Fan <peng.fan at nxp.com>
---
  - v2 changes:
    - use device_property_read_u32() to read the property
    - clean up the goto return, return directly
    - sort the header file alphabetically
    - rename the file to add 'nxp' prefix

  - v3 changes:
    - get the regmap directly from the parent node
---
 drivers/input/keyboard/Kconfig            |  11 ++
 drivers/input/keyboard/Makefile           |   1 +
 drivers/input/keyboard/nxp-bbnsm-pwrkey.c | 190 ++++++++++++++++++++++
 3 files changed, 202 insertions(+)
 create mode 100644 drivers/input/keyboard/nxp-bbnsm-pwrkey.c

diff --git a/drivers/input/keyboard/Kconfig b/drivers/input/keyboard/Kconfig
index 84490915ae4d..43827e34f276 100644
--- a/drivers/input/keyboard/Kconfig
+++ b/drivers/input/keyboard/Kconfig
@@ -456,6 +456,17 @@ config KEYBOARD_SNVS_PWRKEY
 	  To compile this driver as a module, choose M here; the
 	  module will be called snvs_pwrkey.
 
+config KEYBOARD_BBNSM_PWRKEY
+	tristate "NXP BBNSM Power Key Driver"
+	depends on ARCH_MXC || COMPILE_TEST
+	depends on OF
+	help
+	  This is the bbnsm powerkey driver for the NXP i.MX application
+	  processors.
+
+	  To compile this driver as a module, choose M here; the
+	  module will be called bbnsm_pwrkey.
+
 config KEYBOARD_IMX
 	tristate "IMX keypad support"
 	depends on ARCH_MXC || COMPILE_TEST
diff --git a/drivers/input/keyboard/Makefile b/drivers/input/keyboard/Makefile
index 5f67196bb2c1..e34dd65a34c3 100644
--- a/drivers/input/keyboard/Makefile
+++ b/drivers/input/keyboard/Makefile
@@ -13,6 +13,7 @@ obj-$(CONFIG_KEYBOARD_AMIGA)		+= amikbd.o
 obj-$(CONFIG_KEYBOARD_APPLESPI)		+= applespi.o
 obj-$(CONFIG_KEYBOARD_ATARI)		+= atakbd.o
 obj-$(CONFIG_KEYBOARD_ATKBD)		+= atkbd.o
+obj-$(CONFIG_KEYBOARD_BBNSM_PWRKEY)	+= nxp-bbnsm-pwrkey.o
 obj-$(CONFIG_KEYBOARD_BCM)		+= bcm-keypad.o
 obj-$(CONFIG_KEYBOARD_CAP11XX)		+= cap11xx.o
 obj-$(CONFIG_KEYBOARD_CLPS711X)		+= clps711x-keypad.o
diff --git a/drivers/input/keyboard/nxp-bbnsm-pwrkey.c b/drivers/input/keyboard/nxp-bbnsm-pwrkey.c
new file mode 100644
index 000000000000..dc937036c952
--- /dev/null
+++ b/drivers/input/keyboard/nxp-bbnsm-pwrkey.c
@@ -0,0 +1,190 @@
+// SPDX-License-Identifier: GPL-2.0+
+//
+// Copyright 2022 NXP.
+
+#include <linux/device.h>
+#include <linux/err.h>
+#include <linux/init.h>
+#include <linux/input.h>
+#include <linux/interrupt.h>
+#include <linux/io.h>
+#include <linux/jiffies.h>
+#include <linux/kernel.h>
+#include <linux/mfd/syscon.h>
+#include <linux/module.h>
+#include <linux/of.h>
+#include <linux/of_address.h>
+#include <linux/platform_device.h>
+#include <linux/pm_wakeirq.h>
+#include <linux/regmap.h>
+
+#define BBNSM_CTRL		0x8
+#define BBNSM_INT_EN		0x10
+#define BBNSM_EVENTS		0x14
+#define BBNSM_PAD_CTRL		0x24
+
+#define BBNSM_BTN_PRESSED	BIT(7)
+#define BBNSM_PWR_ON		BIT(6)
+#define BBNSM_BTN_OFF		BIT(5)
+#define BBNSM_EMG_OFF		BIT(4)
+#define BBNSM_PWRKEY_EVENTS	(BBNSM_PWR_ON | BBNSM_BTN_OFF | BBNSM_EMG_OFF)
+#define BBNSM_DP_EN		BIT(24)
+
+#define DEBOUNCE_TIME		30
+#define REPEAT_INTERVAL		60
+
+struct bbnsm_pwrkey {
+	struct regmap *regmap;
+	int irq;
+	int keycode;
+	int keystate;  /* 1:pressed */
+	struct timer_list check_timer;
+	struct input_dev *input;
+};
+
+static void bbnsm_pwrkey_check_for_events(struct timer_list *t)
+{
+	struct bbnsm_pwrkey *bbnsm = from_timer(bbnsm, t, check_timer);
+	struct input_dev *input = bbnsm->input;
+	u32 state;
+
+	regmap_read(bbnsm->regmap, BBNSM_EVENTS, &state);
+
+	state = state & BBNSM_BTN_PRESSED ? 1 : 0;
+
+	/* only report new event if status changed */
+	if (state ^ bbnsm->keystate) {
+		bbnsm->keystate = state;
+		input_event(input, EV_KEY, bbnsm->keycode, state);
+		input_sync(input);
+		pm_relax(bbnsm->input->dev.parent);
+	}
+
+	/* repeat check if pressed long */
+	if (state) {
+		mod_timer(&bbnsm->check_timer,
+			  jiffies + msecs_to_jiffies(REPEAT_INTERVAL));
+	}
+}
+
+static irqreturn_t bbnsm_pwrkey_interrupt(int irq, void *dev_id)
+{
+	struct platform_device *pdev = dev_id;
+	struct bbnsm_pwrkey *bbnsm = platform_get_drvdata(pdev);
+	struct input_dev *input = bbnsm->input;
+	u32 event;
+
+	regmap_read(bbnsm->regmap, BBNSM_EVENTS, &event);
+	if (event & BBNSM_BTN_OFF)
+		mod_timer(&bbnsm->check_timer, jiffies + msecs_to_jiffies(DEBOUNCE_TIME));
+	else
+		return IRQ_NONE;
+
+	pm_wakeup_event(input->dev.parent, 0);
+
+	/* clear PWR OFF */
+	regmap_write(bbnsm->regmap, BBNSM_EVENTS, BBNSM_BTN_OFF);
+
+	return IRQ_HANDLED;
+}
+
+static void bbnsm_pwrkey_act(void *pdata)
+{
+	struct bbnsm_pwrkey *bbnsm = pdata;
+
+	del_timer_sync(&bbnsm->check_timer);
+}
+
+static int bbnsm_pwrkey_probe(struct platform_device *pdev)
+{
+	struct bbnsm_pwrkey *bbnsm;
+	struct input_dev *input;
+	struct device_node *np = pdev->dev.of_node;
+	int error;
+
+	bbnsm = devm_kzalloc(&pdev->dev, sizeof(*bbnsm), GFP_KERNEL);
+	if (!bbnsm)
+		return -ENOMEM;
+
+	bbnsm->regmap = syscon_node_to_regmap(np->parent);
+	if (IS_ERR(bbnsm->regmap)) {
+		dev_err(&pdev->dev, "bbnsm pwerkey get regmap failed\n");
+		return PTR_ERR(bbnsm->regmap);
+	}
+
+	if (of_property_read_u32(np, "linux,code", &bbnsm->keycode)) {
+		bbnsm->keycode = KEY_POWER;
+		dev_warn(&pdev->dev, "KEY_POWER without setting in dts\n");
+	}
+
+	bbnsm->irq = platform_get_irq(pdev, 0);
+	if (bbnsm->irq < 0)
+		return -EINVAL;
+
+	/* config the BBNSM power related register */
+	regmap_update_bits(bbnsm->regmap, BBNSM_CTRL, BBNSM_DP_EN, BBNSM_DP_EN);
+
+	/* clear the unexpected interrupt before driver ready */
+	regmap_write_bits(bbnsm->regmap, BBNSM_EVENTS, BBNSM_PWRKEY_EVENTS, BBNSM_PWRKEY_EVENTS);
+
+	timer_setup(&bbnsm->check_timer, bbnsm_pwrkey_check_for_events, 0);
+
+	input = devm_input_allocate_device(&pdev->dev);
+	if (!input) {
+		dev_err(&pdev->dev, "failed to allocate the input device\n");
+		return -ENOMEM;
+	}
+
+	input->name = pdev->name;
+	input->phys = "bbnsm-pwrkey/input0";
+	input->id.bustype = BUS_HOST;
+
+	input_set_capability(input, EV_KEY, bbnsm->keycode);
+
+	/* input customer action to cancel release timer */
+	error = devm_add_action(&pdev->dev, bbnsm_pwrkey_act, bbnsm);
+	if (error) {
+		dev_err(&pdev->dev, "failed to register remove action\n");
+		return error;
+	}
+
+	bbnsm->input = input;
+	platform_set_drvdata(pdev, bbnsm);
+
+	error = devm_request_irq(&pdev->dev, bbnsm->irq, bbnsm_pwrkey_interrupt,
+			       IRQF_SHARED, pdev->name, pdev);
+	if (error) {
+		dev_err(&pdev->dev, "interrupt not available.\n");
+		return error;
+	}
+
+	error = input_register_device(input);
+	if (error < 0) {
+		dev_err(&pdev->dev, "failed to register input device\n");
+		return error;
+	}
+
+	device_init_wakeup(&pdev->dev, true);
+	dev_pm_set_wake_irq(&pdev->dev, bbnsm->irq);
+
+	return 0;
+}
+
+static const struct of_device_id bbnsm_pwrkey_ids[] = {
+	{ .compatible = "nxp,bbnsm-pwrkey" },
+	{ /* sentinel */ }
+};
+MODULE_DEVICE_TABLE(of, bbnsm_pwrkey_ids);
+
+static struct platform_driver bbnsm_pwrkey_driver = {
+	.driver = {
+		.name = "bbnsm_pwrkey",
+		.of_match_table = bbnsm_pwrkey_ids,
+	},
+	.probe = bbnsm_pwrkey_probe,
+};
+module_platform_driver(bbnsm_pwrkey_driver);
+
+MODULE_AUTHOR("Jacky Bai <ping.bai at nxp.com>");
+MODULE_DESCRIPTION("NXP bbnsm power key Driver");
+MODULE_LICENSE("GPL");
-- 
2.37.1




More information about the linux-arm-kernel mailing list