[PATCH v2 1/4] dt-bindings: firmware: xilinx: Describe missing child nodes

[Krzysztof Kozlowski]

On 20/12/2023 11:00, Michal Simek wrote:
> +  gpio:
> +    $ref: /schemas/gpio/xlnx,zynqmp-gpio-modepin.yaml#
> +    description: The gpio node describes connect to PS_MODE pins via firmware
> +      interface.
> +    type: object
> +
> +  pcap:
> +    $ref: /schemas/fpga/xlnx,zynqmp-pcap-fpga.yaml
> +    description: The ZynqMP SoC uses the PCAP (Processor Configuration Port) to
> +      configure the Programmable Logic (PL). The configuration uses the
> +      firmware interface.
> +    type: object
> +
> +  pinctrl:
> +    $ref: /schemas/pinctrl/xlnx,zynqmp-pinctrl.yaml#
> +    description: The pinctrl node provides access to pinconfig and pincontrol
> +      functionality available in firmware.
> +    type: object
> +
> +  power-controller:
> +    $ref: /schemas/power/reset/xlnx,zynqmp-power.yaml#

This should be "power-controller" only if it is a power domain provider.
Is it? Bot's report suggest it is not, therefore I suggested
power-management.

Also, please extend the example. The top-level example for complex
devices should be complete. Apologies for not bringing it earlier.

Best regards,
Krzysztof