[PATCH v9 6/7] arm64: dts: ti: k3-j721e-sk: Add TPS6594 family PMICs

[Nishanth Menon]

On 15:04-20231205, Neha Malcom Francis wrote:
> This patch adds support for TPS6594 PMIC family on wakeup I2C0 bus.
> These devices provide regulators (bucks and LDOs), but also GPIOs, a
> RTC, a watchdog, an ESM (Error Signal Monitor) which monitors the SoC
> error output signal, and a PFSM (Pre-configurable Finite State Machine)
> which manages the operational modes of the PMIC.
> 
> Signed-off-by: Neha Malcom Francis <n-francis at ti.com>
> ---
>  arch/arm64/boot/dts/ti/k3-j721e-sk.dts | 158 +++++++++++++++++++++++++
>  1 file changed, 158 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/ti/k3-j721e-sk.dts b/arch/arm64/boot/dts/ti/k3-j721e-sk.dts
> index 42fe8eee9ec8..e600825f7e78 100644
> --- a/arch/arm64/boot/dts/ti/k3-j721e-sk.dts
> +++ b/arch/arm64/boot/dts/ti/k3-j721e-sk.dts
> @@ -459,6 +459,13 @@ J721E_IOPAD(0x234, PIN_INPUT, 7) /* (U3) EXT_REFCLK1.GPIO1_12 */
>  };
>  
>  &wkup_pmx0 {
> +	pmic_irq_pins_default: pmic-irq-default-pins {
> +		bootph-pre-ram;
> +		pinctrl-single,pins = <
> +			J721E_WKUP_IOPAD(0x0cc, PIN_INPUT, 7) /* (G28) WKUP_GPIO0_7 */
> +		>;
> +	};
> +
>  	mcu_cpsw_pins_default: mcu-cpsw-default-pins {
>  		pinctrl-single,pins = <
>  			J721E_WKUP_IOPAD(0x84, PIN_INPUT, 0) /* (B24) MCU_RGMII1_RD0 */
> @@ -560,6 +567,157 @@ eeprom at 51 {
>  		compatible = "atmel,24c512";
>  		reg = <0x51>;
>  	};
> +
> +	tps659413: pmic at 48 {
> +		bootph-pre-ram;

only for the leaf nodes. See
https://libera.irclog.whitequark.org/armlinux/2023-10-19

> +		compatible = "ti,tps6594-q1";
> +		reg = <0x48>;
> +		system-power-controller;
> +		pinctrl-names = "default";
> +		pinctrl-0 = <&pmic_irq_pins_default>;
> +		interrupt-parent = <&wkup_gpio0>;
> +		interrupts = <9 IRQ_TYPE_EDGE_FALLING>;
> +		ti,primary-pmic;
> +
> +		gpio-controller;
> +		#gpio-cells = <2>;
> +
> +		buck123-supply = <&vsys_3v3>;
> +		buck4-supply = <&vsys_3v3>;
> +		buck5-supply = <&vsys_3v3>;
> +		ldo1-supply = <&vsys_3v3>;
> +		ldo2-supply = <&vsys_3v3>;
> +		ldo3-supply = <&vsys_3v3>;
> +		ldo4-supply = <&vsys_3v3>;
> +
> +		regulators {
> +			bootph-pre-ram;
> +			bucka123: buck123 {
> +				bootph-pre-ram;
> +				regulator-name = "vdd_cpu_avs";
> +				regulator-min-microvolt = <600000>;
> +				regulator-max-microvolt = <900000>;
> +				regulator-boot-on;
> +				regulator-always-on;
> +			};
> +
> +			bucka4: buck4 {
> +				regulator-name = "vdd_mcu_0v85";
> +				regulator-min-microvolt = <850000>;
> +				regulator-max-microvolt = <850000>;
> +				regulator-boot-on;
> +				regulator-always-on;
> +			};
> +
> +			bucka5: buck5 {
> +				regulator-name = "vdd_phyio_1v8";
> +				regulator-min-microvolt = <1800000>;
> +				regulator-max-microvolt = <1800000>;
> +				regulator-boot-on;
> +				regulator-always-on;
> +			};
> +
> +			ldoa1: ldo1 {
> +				regulator-name = "vdd1_lpddr4_1v8";
> +				regulator-min-microvolt = <1800000>;
> +				regulator-max-microvolt = <1800000>;
> +				regulator-boot-on;
> +				regulator-always-on;
> +			};
> +
> +			ldoa2: ldo2 {
> +				regulator-name = "vdd_mcuio_1v8";
> +				regulator-min-microvolt = <1800000>;
> +				regulator-max-microvolt = <1800000>;
> +				regulator-boot-on;
> +				regulator-always-on;
> +			};
> +
> +			ldoa3: ldo3 {
> +				regulator-name = "vdda_dll_0v8";
> +				regulator-min-microvolt = <800000>;
> +				regulator-max-microvolt = <800000>;
> +				regulator-boot-on;
> +				regulator-always-on;
> +			};
> +
> +			ldoa4: ldo4 {
> +				regulator-name = "vda_mcu_1v8";
> +				regulator-min-microvolt = <1800000>;
> +				regulator-max-microvolt = <1800000>;
> +				regulator-boot-on;
> +				regulator-always-on;
> +			};
> +		};
> +	};
> +
> +	tps659411: pmic at 4c {
> +		compatible = "ti,tps6594-q1";
> +		reg = <0x4c>;
> +		system-power-controller;
> +		interrupt-parent = <&wkup_gpio0>;
> +		interrupts = <9 IRQ_TYPE_EDGE_FALLING>;
> +
> +		gpio-controller;
> +		#gpio-cells = <2>;
> +
> +		buck1234-supply = <&vsys_3v3>;
> +		buck5-supply = <&vsys_3v3>;
> +		ldo1-supply = <&vsys_3v3>;
> +		ldo2-supply = <&vsys_3v3>;
> +		ldo3-supply = <&vsys_3v3>;
> +		ldo4-supply = <&vsys_3v3>;
> +
> +		regulators {
> +			buckb1234: buck1234 {
> +				regulator-name = "vdd_core_0v8";
> +				regulator-min-microvolt = <800000>;
> +				regulator-max-microvolt = <800000>;
> +				regulator-boot-on;
> +				regulator-always-on;
> +			};
> +
> +			buckb5: buck5 {
> +				regulator-name = "vdd_ram_0v85";
> +				regulator-min-microvolt = <850000>;
> +				regulator-max-microvolt = <850000>;
> +				regulator-boot-on;
> +				regulator-always-on;
> +			};
> +
> +			ldob1: ldo1 {
> +				regulator-name = "vdd_sd_dv";
> +				regulator-min-microvolt = <1800000>;
> +				regulator-max-microvolt = <3300000>;
> +				regulator-boot-on;
> +				regulator-always-on;
> +			};
> +
> +			ldob2: ldo2 {
> +				regulator-name = "vdd_usb_3v3";
> +				regulator-min-microvolt = <3300000>;
> +				regulator-max-microvolt = <3300000>;
> +				regulator-boot-on;
> +				regulator-always-on;
> +			};
> +
> +			ldob3: ldo3 {
> +				regulator-name = "vdd_io_1v8";
> +				regulator-min-microvolt = <1800000>;
> +				regulator-max-microvolt = <1800000>;
> +				regulator-boot-on;
> +				regulator-always-on;
> +			};
> +
> +			ldob4: ldo4 {
> +				regulator-name = "vda_pll_1v8";
> +				regulator-min-microvolt = <1800000>;
> +				regulator-max-microvolt = <1800000>;
> +				regulator-boot-on;
> +				regulator-always-on;
> +			};
> +		};
> +	};
>  };
>  
>  &mcu_uart0 {
> -- 
> 2.34.1
> 

-- 
Regards,
Nishanth Menon
Key (0xDDB5849D1736249D) / Fingerprint: F8A2 8693 54EB 8232 17A3  1A34 DDB5 849D 1736 249D