[PATCH v9 06/13] media: cadence: csi2rx: Configure DPHY using link freq

[Jai Luthra]

From: Pratyush Yadav <p.yadav at ti.com>

Some platforms like TI's J721E can have the CSI2RX paired with an
external DPHY. Use the generic PHY framework to configure the DPHY with
the correct link frequency.

Signed-off-by: Pratyush Yadav <p.yadav at ti.com>
Co-authored-by: Jai Luthra <j-luthra at ti.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart at ideasonboard.com>
Reviewed-by: Tomi Valkeinen <tomi.valkeinen at ideasonboard.com>
Reviewed-by: Maxime Ripard <mripard at kernel.org>
Signed-off-by: Jai Luthra <j-luthra at ti.com>
---
Changes from v8:
    - Don't specify stream while calling .get_fmt()

 drivers/media/platform/cadence/cdns-csi2rx.c | 24 ++++++++++++++++++++++++
 1 file changed, 24 insertions(+)

diff --git a/drivers/media/platform/cadence/cdns-csi2rx.c b/drivers/media/platform/cadence/cdns-csi2rx.c
index 047e74ee2443..933edec89520 100644
--- a/drivers/media/platform/cadence/cdns-csi2rx.c
+++ b/drivers/media/platform/cadence/cdns-csi2rx.c
@@ -145,8 +145,32 @@ static void csi2rx_reset(struct csi2rx_priv *csi2rx)
 static int csi2rx_configure_ext_dphy(struct csi2rx_priv *csi2rx)
 {
 	union phy_configure_opts opts = { };
+	struct phy_configure_opts_mipi_dphy *cfg = &opts.mipi_dphy;
+	struct v4l2_subdev_format sd_fmt = {
+		.which	= V4L2_SUBDEV_FORMAT_ACTIVE,
+		.pad	= CSI2RX_PAD_SINK,
+	};
+	const struct csi2rx_fmt *fmt;
+	s64 link_freq;
 	int ret;
 
+	ret = v4l2_subdev_call_state_active(&csi2rx->subdev, pad, get_fmt,
+					    &sd_fmt);
+	if (ret < 0)
+		return ret;
+
+	fmt = csi2rx_get_fmt_by_code(sd_fmt.format.code);
+
+	link_freq = v4l2_get_link_freq(csi2rx->source_subdev->ctrl_handler,
+				       fmt->bpp, 2 * csi2rx->num_lanes);
+	if (link_freq < 0)
+		return link_freq;
+
+	ret = phy_mipi_dphy_get_default_config_for_hsclk(link_freq,
+							 csi2rx->num_lanes, cfg);
+	if (ret)
+		return ret;
+
 	ret = phy_power_on(csi2rx->dphy);
 	if (ret)
 		return ret;

-- 
2.41.0