[PATCH 06/11] arm64: dts: ti: k3-am65: MDIO pinmux should belong to the MDIO node

[Andrew Davis]

Although usually integrated as a child of an Ethernet controller, MDIO
IP has an independent pinout. This pinout should be controlled by
the MDIO node (so if it was to be disabled for instance, the pinmux
state would reflect that).

Move the MDIO pins pinmux to the MIDO nodes.

Signed-off-by: Andrew Davis <afd at ti.com>
---
 arch/arm64/boot/dts/ti/k3-am654-base-board.dts | 5 ++++-
 1 file changed, 4 insertions(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/ti/k3-am654-base-board.dts b/arch/arm64/boot/dts/ti/k3-am654-base-board.dts
index f4b8747ebaef6..0c63c24941061 100644
--- a/arch/arm64/boot/dts/ti/k3-am654-base-board.dts
+++ b/arch/arm64/boot/dts/ti/k3-am654-base-board.dts
@@ -529,10 +529,13 @@ flash at 0 {
 
 &mcu_cpsw {
 	pinctrl-names = "default";
-	pinctrl-0 = <&mcu_cpsw_pins_default &mcu_mdio_pins_default>;
+	pinctrl-0 = <&mcu_cpsw_pins_default>;
 };
 
 &davinci_mdio {
+	pinctrl-names = "default";
+	pinctrl-0 = <&mcu_mdio_pins_default>;
+
 	phy0: ethernet-phy at 0 {
 		reg = <0>;
 		ti,rx-internal-delay = <DP83867_RGMIIDCTL_2_00_NS>;
-- 
2.37.3