[PATCH] arm64: dts: renesas: r8a779f0: Add CA55 operating points

[Geert Uytterhoeven]

Add operating points for running the Cortex-A55 CPU cores on R-Car S4-8
at various speeds, up to the maximum supported frequency (1200 MHz).

R-Car S4-8 has 8 Cortex-A55 cores, grouped in 4 clusters.
CA55 Sub-System 0 (first 2 clusters / CPU cores 0-3) is clocked by Z0φ.
CA55 Sub-System 1 (last 2 clusters / CPU cores 4-7) is clocked by Z1φ.

As the two sets of clusters are driven by separate clocks, this requires
specifying two separate tables (using the same operating performance
point values), with "opp-shared" to indicate that the CPU cores in each
set share state.

Based on a patch in the BSP by Tho Vu.

Signed-off-by: Geert Uytterhoeven <geert+renesas at glider.be>
---
To be queued in renesas-devel for v6.3.

Changes compared to the BSP:
  - Use two tables.

Tested on the Renesas Spider development board by using the CPUfreq
userspace governor, writing the desired CPU clock rate to the CPUfreq
policy's "scaling_setspeed" file in sysfs, verifying the clock rate of
the Z0φ and Z1φ clocks in debugfs, and running the dhrystones benchmark
on the various CPU cores.

The Linux cpufreq driver creates two policies under
/sys/devices/system/cpu/cpufreq/: "policy0" and "policy4".

With a single table and "opp-shared", only "policy0" would be created,
and clock Z1φ would never be changed.
With a single table and without "opp-shared", 8 policies would be
created, and the rate of clocks Z0φ and Z1φ would reflect the value for
the last touched CPU core from the corresponding set.
---
 arch/arm64/boot/dts/renesas/r8a779f0.dtsi | 62 +++++++++++++++++++++++
 1 file changed, 62 insertions(+)

diff --git a/arch/arm64/boot/dts/renesas/r8a779f0.dtsi b/arch/arm64/boot/dts/renesas/r8a779f0.dtsi
index 67a4f2d4480d8450..ac294168c86785db 100644
--- a/arch/arm64/boot/dts/renesas/r8a779f0.dtsi
+++ b/arch/arm64/boot/dts/renesas/r8a779f0.dtsi
@@ -14,6 +14,60 @@ / {
 	#address-cells = <2>;
 	#size-cells = <2>;
 
+	cluster01_opp: opp-table-0 {
+		compatible = "operating-points-v2";
+		opp-shared;
+
+		opp-500000000 {
+			opp-hz = /bits/ 64 <500000000>;
+			opp-microvolt = <880000>;
+			clock-latency-ns = <500000>;
+		};
+		opp-800000000 {
+			opp-hz = /bits/ 64 <800000000>;
+			opp-microvolt = <880000>;
+			clock-latency-ns = <500000>;
+		};
+		opp-1000000000 {
+			opp-hz = /bits/ 64 <1000000000>;
+			opp-microvolt = <880000>;
+			clock-latency-ns = <500000>;
+		};
+		opp-1200000000 {
+			opp-hz = /bits/ 64 <1200000000>;
+			opp-microvolt = <880000>;
+			clock-latency-ns = <500000>;
+			opp-suspend;
+		};
+	};
+
+	cluster23_opp: opp-table-1 {
+		compatible = "operating-points-v2";
+		opp-shared;
+
+		opp-500000000 {
+			opp-hz = /bits/ 64 <500000000>;
+			opp-microvolt = <880000>;
+			clock-latency-ns = <500000>;
+		};
+		opp-800000000 {
+			opp-hz = /bits/ 64 <800000000>;
+			opp-microvolt = <880000>;
+			clock-latency-ns = <500000>;
+		};
+		opp-1000000000 {
+			opp-hz = /bits/ 64 <1000000000>;
+			opp-microvolt = <880000>;
+			clock-latency-ns = <500000>;
+		};
+		opp-1200000000 {
+			opp-hz = /bits/ 64 <1200000000>;
+			opp-microvolt = <880000>;
+			clock-latency-ns = <500000>;
+			opp-suspend;
+		};
+	};
+
 	cpus {
 		#address-cells = <1>;
 		#size-cells = <0>;
@@ -65,6 +119,7 @@ a55_0: cpu at 0 {
 			enable-method = "psci";
 			cpu-idle-states = <&CPU_SLEEP_0>;
 			clocks = <&cpg CPG_CORE R8A779F0_CLK_Z0>;
+			operating-points-v2 = <&cluster01_opp>;
 		};
 
 		a55_1: cpu at 100 {
@@ -76,6 +131,7 @@ a55_1: cpu at 100 {
 			enable-method = "psci";
 			cpu-idle-states = <&CPU_SLEEP_0>;
 			clocks = <&cpg CPG_CORE R8A779F0_CLK_Z0>;
+			operating-points-v2 = <&cluster01_opp>;
 		};
 
 		a55_2: cpu at 10000 {
@@ -87,6 +143,7 @@ a55_2: cpu at 10000 {
 			enable-method = "psci";
 			cpu-idle-states = <&CPU_SLEEP_0>;
 			clocks = <&cpg CPG_CORE R8A779F0_CLK_Z0>;
+			operating-points-v2 = <&cluster01_opp>;
 		};
 
 		a55_3: cpu at 10100 {
@@ -98,6 +155,7 @@ a55_3: cpu at 10100 {
 			enable-method = "psci";
 			cpu-idle-states = <&CPU_SLEEP_0>;
 			clocks = <&cpg CPG_CORE R8A779F0_CLK_Z0>;
+			operating-points-v2 = <&cluster01_opp>;
 		};
 
 		a55_4: cpu at 20000 {
@@ -109,6 +167,7 @@ a55_4: cpu at 20000 {
 			enable-method = "psci";
 			cpu-idle-states = <&CPU_SLEEP_0>;
 			clocks = <&cpg CPG_CORE R8A779F0_CLK_Z1>;
+			operating-points-v2 = <&cluster23_opp>;
 		};
 
 		a55_5: cpu at 20100 {
@@ -120,6 +179,7 @@ a55_5: cpu at 20100 {
 			enable-method = "psci";
 			cpu-idle-states = <&CPU_SLEEP_0>;
 			clocks = <&cpg CPG_CORE R8A779F0_CLK_Z1>;
+			operating-points-v2 = <&cluster23_opp>;
 		};
 
 		a55_6: cpu at 30000 {
@@ -131,6 +191,7 @@ a55_6: cpu at 30000 {
 			enable-method = "psci";
 			cpu-idle-states = <&CPU_SLEEP_0>;
 			clocks = <&cpg CPG_CORE R8A779F0_CLK_Z1>;
+			operating-points-v2 = <&cluster23_opp>;
 		};
 
 		a55_7: cpu at 30100 {
@@ -142,6 +203,7 @@ a55_7: cpu at 30100 {
 			enable-method = "psci";
 			cpu-idle-states = <&CPU_SLEEP_0>;
 			clocks = <&cpg CPG_CORE R8A779F0_CLK_Z1>;
+			operating-points-v2 = <&cluster23_opp>;
 		};
 
 		L3_CA55_0: cache-controller-0 {
-- 
2.25.1