[PATCH v3 RESEND net-next 0/3] net: axienet: Use a DT property to configure frequency of the MDIO bus

[Andy Chiu]

Some FPGA platforms have to set frequency of the MDIO bus lower than 2.5
MHz. Thus, we use a DT property, which is "clock-frequency", to work
with it at boot time. The default 2.5 MHz would be set if the property
is not pressent. Also, factor out mdio enable/disable functions due to
the api change since 253761a0e61b7.

Changelog:
--- v3 RESEND ---
1. Repost the exact same patch again
--- v3 ---
1. Fix coding style, and make probing of the driver fail if MDC overflow
--- v2 ---
1. Use clock-frequency, as defined in mdio.yaml, to configure MDIO
   clock.
2. Only print out frequency if it is set to a non-standard value.
3. Reduce the scope of axienet_mdio_enable and remove
   axienet_mdio_disable because no one really uses it anymore.

Andy Chiu (3):
  net: axienet: Unexport and remove unused mdio functions
  net: axienet: set mdio clock according to bus-frequency
  dt-bindings: describe the support of "clock-frequency" in mdio

 .../bindings/net/xilinx_axienet.txt           |  2 +
 drivers/net/ethernet/xilinx/xilinx_axienet.h  |  2 -
 .../net/ethernet/xilinx/xilinx_axienet_mdio.c | 57 +++++++++++--------
 3 files changed, 34 insertions(+), 27 deletions(-)

-- 
2.36.0