[PATCH] arm64: defconfig: Enable modules for arm displays

[Sudeep Holla]

On Tue, May 10, 2022 at 01:34:00PM +0100, Carsten Haitzler wrote:
> 
> 
> On 5/10/22 13:07, Sudeep Holla wrote:
> > On Tue, May 10, 2022 at 12:27:50PM +0100, Mark Brown wrote:
> > > On Tue, May 10, 2022 at 12:15:45PM +0100, Sudeep Holla wrote:
> > > 
> > > > While at it, can we get these too enabled which are needed on JUNO IIUC.
> > > > CONFIG_DRM_I2C_NXP_TDA998X
> > > > CONFIG_DRM_I2C_NXP_TDA9950
> > > 
> > > > Liviu/Robin who use HDLCD more than me on Juno can confirm if these are
> > > > needed or not. I seem to have these for some HDLCD clock testing using SCMI.
> > > 
> > > Those two, especially TDA998x, are very widely used so should probably
> > > just be enabled anyway regardless of what's on Juno.
> > 
> > Indeed, Robin mentioned the same. I am just adding it blindly every time
> > I need to test HDLCD without noticing any warnings.
> > 
> 
> Yup - those were already there. I was just adding these for our new Morello
> board - all it needed was I2C Cadence enabled as a module and presto... it
> "just works". As it's just a module it's not really a bad "cost" so
> defconfig additions seemed the right thing to do. Just chasing up this patch
> as I sent it earlier this year and it was not merged or denied... :)

Was it sent to soc at kernel.org earlier as well ? If so, let me know. I am
not sure if the SoC team expects this to come from some platform maintainer
or atleast an ack from them so that they can pick up. We can just say it
is need for Arm Ltd platforms and provide an ack(me or Liviu).

-- 
Regards,
Sudeep