[PATCH] arm64: defconfig: Enable modules for arm displays

[Carsten Haitzler]

On 5/10/22 13:07, Sudeep Holla wrote:
> On Tue, May 10, 2022 at 12:27:50PM +0100, Mark Brown wrote:
>> On Tue, May 10, 2022 at 12:15:45PM +0100, Sudeep Holla wrote:
>>
>>> While at it, can we get these too enabled which are needed on JUNO IIUC.
>>> CONFIG_DRM_I2C_NXP_TDA998X
>>> CONFIG_DRM_I2C_NXP_TDA9950
>>
>>> Liviu/Robin who use HDLCD more than me on Juno can confirm if these are
>>> needed or not. I seem to have these for some HDLCD clock testing using SCMI.
>>
>> Those two, especially TDA998x, are very widely used so should probably
>> just be enabled anyway regardless of what's on Juno.
> 
> Indeed, Robin mentioned the same. I am just adding it blindly every time
> I need to test HDLCD without noticing any warnings.
> 

Yup - those were already there. I was just adding these for our new 
Morello board - all it needed was I2C Cadence enabled as a module and 
presto... it "just works". As it's just a module it's not really a bad 
"cost" so defconfig additions seemed the right thing to do. Just chasing 
up this patch as I sent it earlier this year and it was not merged or 
denied... :)