[PATCH V2 2/6] spi: mediatek: add IPM single mode design support

[AngeloGioacchino Del Regno]

Il 21/02/22 05:07, Leilk Liu ha scritto:
> this patch add the support of IPM single mode design.
> 
> Signed-off-by: Leilk Liu <leilk.liu at mediatek.com>
> ---
>   drivers/spi/spi-mt65xx.c | 103 +++++++++++++++++++++++++++++++++------
>   1 file changed, 87 insertions(+), 16 deletions(-)
> 
> diff --git a/drivers/spi/spi-mt65xx.c b/drivers/spi/spi-mt65xx.c
> index bbfeb8046c17..5fa677a589a4 100644
> --- a/drivers/spi/spi-mt65xx.c
> +++ b/drivers/spi/spi-mt65xx.c
> @@ -31,6 +31,7 @@
>   #define SPI_CFG2_REG                      0x0028
>   #define SPI_TX_SRC_REG_64                 0x002c
>   #define SPI_RX_DST_REG_64                 0x0030
> +#define SPI_CFG3_IPM_REG                  0x0040
>   
>   #define SPI_CFG0_SCK_HIGH_OFFSET          0
>   #define SPI_CFG0_SCK_LOW_OFFSET           8
> @@ -48,6 +49,7 @@
>   #define SPI_CFG1_CS_IDLE_MASK             0xff
>   #define SPI_CFG1_PACKET_LOOP_MASK         0xff00
>   #define SPI_CFG1_PACKET_LENGTH_MASK       0x3ff0000
> +#define SPI_CFG1_IPM_PACKET_LENGTH_MASK   GENMASK(31, 16)
>   #define SPI_CFG2_SCK_HIGH_OFFSET          0
>   #define SPI_CFG2_SCK_LOW_OFFSET           16
>   
> @@ -68,7 +70,13 @@
>   #define SPI_CMD_TX_ENDIAN            BIT(15)
>   #define SPI_CMD_FINISH_IE            BIT(16)
>   #define SPI_CMD_PAUSE_IE             BIT(17)
> +#define SPI_CMD_IPM_NONIDLE_MODE     BIT(19)
> +#define SPI_CMD_IPM_SPIM_LOOP        BIT(21)
> +#define SPI_CMD_IPM_GET_TICKDLY_OFFSET    22
>   
> +#define SPI_CMD_IPM_GET_TICKDLY_MASK	GENMASK(24, 22)
> +#define SPI_CFG3_IPM_HALF_DUPLEX_DIR		BIT(2)
> +#define SPI_CFG3_IPM_HALF_DUPLEX_EN		BIT(3)
>   #define MT8173_SPI_MAX_PAD_SEL 3
>   
>   #define MTK_SPI_PAUSE_INT_STATUS 0x2
> @@ -78,6 +86,7 @@
>   
>   #define MTK_SPI_MAX_FIFO_SIZE 32U
>   #define MTK_SPI_PACKET_SIZE 1024
> +#define MTK_SPI_IPM_PACKET_SIZE SZ_64K
>   #define MTK_SPI_32BITS_MASK  (0xffffffff)
>   
>   #define DMA_ADDR_EXT_BITS (36)
> @@ -93,6 +102,9 @@ struct mtk_spi_compatible {
>   	bool dma_ext;
>   	/* some IC no need unprepare SPI clk */
>   	bool no_need_unprepare;
> +	/* IPM design improve some single mode features */
> +	bool ipm_design;
> +
>   };
>   
>   struct mtk_spi {
> @@ -116,6 +128,12 @@ static const struct mtk_spi_compatible mt2712_compat = {
>   	.must_tx = true,
>   };
>   
> +static const struct mtk_spi_compatible ipm_compat_single = {
> +	.enhance_timing = true,
> +	.dma_ext = true,
> +	.ipm_design = true,
> +};
> +
>   static const struct mtk_spi_compatible mt6765_compat = {
>   	.need_pad_sel = true,
>   	.must_tx = true,
> @@ -157,6 +175,9 @@ static const struct mtk_chip_config mtk_default_chip_info = {
>   };
>   
>   static const struct of_device_id mtk_spi_of_match[] = {
> +	{ .compatible = "mediatek,ipm-spi-single",
> +		.data = (void *)&ipm_compat_single,
> +	},
>   	{ .compatible = "mediatek,mt2701-spi",
>   		.data = (void *)&mtk_common_compat,
>   	},
> @@ -275,12 +296,11 @@ static int mtk_spi_set_hw_cs_timing(struct spi_device *spi)
>   	return 0;
>   }
>   
> -static int mtk_spi_prepare_message(struct spi_master *master,
> -				   struct spi_message *msg)
> +static int mtk_spi_hw_init(struct spi_master *master,
> +			   struct spi_device *spi)
>   {
>   	u16 cpha, cpol;
>   	u32 reg_val;
> -	struct spi_device *spi = msg->spi;
>   	struct mtk_chip_config *chip_config = spi->controller_data;
>   	struct mtk_spi *mdata = spi_master_get_devdata(master);
>   
> @@ -288,6 +308,15 @@ static int mtk_spi_prepare_message(struct spi_master *master,
>   	cpol = spi->mode & SPI_CPOL ? 1 : 0;
>   
>   	reg_val = readl(mdata->base + SPI_CMD_REG);
> +	if (mdata->dev_comp->ipm_design) {
> +		/* SPI transfer without idle time until packet length done */
> +		reg_val |= SPI_CMD_IPM_NONIDLE_MODE;
> +		if (spi->mode & SPI_LOOP)
> +			reg_val |= SPI_CMD_IPM_SPIM_LOOP;
> +		else
> +			reg_val &= ~SPI_CMD_IPM_SPIM_LOOP;
> +	}
> +
>   	if (cpha)
>   		reg_val |= SPI_CMD_CPHA;
>   	else
> @@ -344,18 +373,33 @@ static int mtk_spi_prepare_message(struct spi_master *master,
>   		writel(mdata->pad_sel[spi->chip_select],
>   		       mdata->base + SPI_PAD_SEL_REG);
>   
> -	/* tick delay */
> -	reg_val = readl(mdata->base + SPI_CFG1_REG);
> -	reg_val &= ~SPI_CFG1_GET_TICK_DLY_MASK;
> -	reg_val |= ((chip_config->tick_delay & 0x7)
> -		<< SPI_CFG1_GET_TICK_DLY_OFFSET);
> -	writel(reg_val, mdata->base + SPI_CFG1_REG);

Hello Leilk,

with this change, you are excluding this code from MT2712: is that
intentional?
If it is, then this should reside in a different commit with a Fixes
tag, also explaining the reason for not setting the tick delay on
that SoC.

Also, please don't remove the /* tick delay */ comment.

Regards,
Angelo

> +	if (mdata->dev_comp->enhance_timing) {
> +		if (mdata->dev_comp->ipm_design) {
> +			reg_val = readl(mdata->base + SPI_CMD_REG);
> +			reg_val &= ~SPI_CMD_IPM_GET_TICKDLY_MASK;
> +			reg_val |= ((chip_config->tick_delay & 0x7)
> +				   << SPI_CMD_IPM_GET_TICKDLY_OFFSET);
> +			writel(reg_val, mdata->base + SPI_CMD_REG);
> +		} else {
> +			reg_val = readl(mdata->base + SPI_CFG1_REG);
> +			reg_val &= ~SPI_CFG1_GET_TICK_DLY_MASK;
> +			reg_val |= ((chip_config->tick_delay & 0x7)
> +				<< SPI_CFG1_GET_TICK_DLY_OFFSET);
> +			writel(reg_val, mdata->base + SPI_CFG1_REG);
> +		}
> +	}
>   
>   	/* set hw cs timing */
>   	mtk_spi_set_hw_cs_timing(spi);
>   	return 0;
>   }