[PATCH v7 7/8] PCI: imx6: Disable enabled clocks and regulators after link is down

[Richard Zhu]

Since i.MX PCIe doesn't support the hot-plug, and to save power
consumption as much as possible. Return error and disable the enabled
clocks and regulators when link is down,.

Add a new host_exit() callback for i.MX PCIe driver to disable the
enabled clocks, regulators and so on in the error handling after
host_init is finished.

Signed-off-by: Richard Zhu <hongxing.zhu at nxp.com>
---
 drivers/pci/controller/dwc/pci-imx6.c | 30 ++++++++++++++++++++++++---
 1 file changed, 27 insertions(+), 3 deletions(-)

diff --git a/drivers/pci/controller/dwc/pci-imx6.c b/drivers/pci/controller/dwc/pci-imx6.c
index 242d8ef73c1e..fe671e88ec93 100644
--- a/drivers/pci/controller/dwc/pci-imx6.c
+++ b/drivers/pci/controller/dwc/pci-imx6.c
@@ -848,7 +848,9 @@ static int imx6_pcie_start_link(struct dw_pcie *pci)
 	/* Start LTSSM. */
 	imx6_pcie_ltssm_enable(dev);
 
-	dw_pcie_wait_for_link(pci);
+	ret = dw_pcie_wait_for_link(pci);
+	if (ret)
+		goto err_reset_phy;
 
 	if (pci->link_gen == 2) {
 		/* Allow Gen2 mode after the link is up. */
@@ -884,7 +886,9 @@ static int imx6_pcie_start_link(struct dw_pcie *pci)
 		}
 
 		/* Make sure link training is finished as well! */
-		dw_pcie_wait_for_link(pci);
+		ret = dw_pcie_wait_for_link(pci);
+		if (ret)
+			goto err_reset_phy;
 	} else {
 		dev_info(dev, "Link: Gen2 disabled\n");
 	}
@@ -897,7 +901,6 @@ static int imx6_pcie_start_link(struct dw_pcie *pci)
 	dev_dbg(dev, "PHY DEBUG_R0=0x%08x DEBUG_R1=0x%08x\n",
 		dw_pcie_readl_dbi(pci, PCIE_PORT_DEBUG0),
 		dw_pcie_readl_dbi(pci, PCIE_PORT_DEBUG1));
-	imx6_pcie_reset_phy(imx6_pcie);
 	return ret;
 }
 
@@ -921,8 +924,29 @@ static int imx6_pcie_host_init(struct pcie_port *pp)
 	return 0;
 }
 
+static void imx6_pcie_host_exit(struct pcie_port *pp)
+{
+	struct dw_pcie *pci = to_dw_pcie_from_pp(pp);
+	struct device *dev = pci->dev;
+	struct imx6_pcie *imx6_pcie = to_imx6_pcie(pci);
+
+	imx6_pcie_reset_phy(imx6_pcie);
+	imx6_pcie_clk_disable(imx6_pcie);
+	switch (imx6_pcie->drvdata->variant) {
+	case IMX8MM:
+		if (phy_power_off(imx6_pcie->phy))
+			dev_err(dev, "unable to power off phy\n");
+		break;
+	default:
+		break;
+	}
+	if (imx6_pcie->vpcie)
+		regulator_disable(imx6_pcie->vpcie);
+}
+
 static const struct dw_pcie_host_ops imx6_pcie_host_ops = {
 	.host_init = imx6_pcie_host_init,
+	.host_exit = imx6_pcie_host_exit,
 };
 
 static const struct dw_pcie_ops dw_pcie_ops = {
-- 
2.25.1