[PATCH] arm64: dts: imx8ulp: Set #thermal-sensor-cells to 1 as required

[Fabio Estevam]

Hi Sudeep,

On Fri, Feb 11, 2022 at 8:02 AM Sudeep Holla <sudeep.holla at arm.com> wrote:
>
> The SCMI binding clearly states the value of #thermal-sensor-cells must
> be 1. However arch/arm64/boot/dts/freescale/imx8ulp.dtsi sets it 0 which
> results in the following warning with dtbs_check:
>
>   |  arch/arm64/boot/dts/freescale/imx8ulp-evk.dt.yaml: scmi:
>   |             protocol at 15:#thermal-sensor-cells:0:0: 1 was expected
>   |     From schema: Documentation/devicetree/bindings/firmware/arm,scmi.yaml
>
> Fix it by setting it to 1 as required.
>
> Cc:Shawn Guo <shawnguo at kernel.org>
> Cc: Sascha Hauer <s.hauer at pengutronix.de>
> Signed-off-by: Sudeep Holla <sudeep.holla at arm.com>

Reviewed-by: Fabio Estevam <festevam at gmail.com>