[PATCH 3/3] arm64: dts: rockchip: Add Pine64 PineNote board

[Johan Jonker]

On 2/2/22 11:41, Johan Jonker wrote:
> Hi Samuel,

> On 1/30/22 06:38, Samuel Holland wrote:

>> +/ {
>> +	aliases {

>> +		mmc0 = &sdhci;

sdmmc1 ??

MMC aliases should be sort on reg address, based on availability and
without number gap.

>> +	};
>> +

[..]

>> +&sdhci {
>> +	bus-width = <8>;
>> +	mmc-hs200-1_8v;
>> +	non-removable;
>> +	pinctrl-0 = <&emmc_bus8>, <&emmc_clk>, <&emmc_cmd>, <&emmc_datastrobe>, <&emmc_rstnout>;
>> +	pinctrl-names = "default";
>> +	vmmc-supply = <&vcc_3v3>;
>> +	vqmmc-supply = <&vcc_1v8>;
>> +	status = "okay";
>> +};
>> +
>> +&sdmmc1 {
>> +	bus-width = <4>;
>> +	cap-sd-highspeed;
>> +	cap-sdio-irq;
> 
>> +	disable-wp;
> 
> From mmc-controller.yaml:
> 
>   disable-wp:
>     $ref: /schemas/types.yaml#/definitions/flag
>     description:
>       When set, no physical write-protect line is present. This
>       property should only be specified when the controller has a
>       dedicated write-protect detection logic. If a GPIO is always used
>       for the write-protect detection logic, it is sufficient to not
>       specify the wp-gpios property in the absence of a write-protect
>       line. Not used in combination with eMMC or SDIO.
> 
>> +	keep-power-in-suspend;
>> +	mmc-pwrseq = <&sdio_pwrseq>;
>> +	non-removable;
>> +	pinctrl-0 = <&sdmmc1_bus4>, <&sdmmc1_clk>, <&sdmmc1_cmd>;
>> +	pinctrl-names = "default";
>> +	sd-uhs-sdr104;
>> +	vmmc-supply = <&vcc_wl>;
>> +	vqmmc-supply = <&vcca_1v8_pmu>;
>> +	status = "okay";
>> +};
>> +