[PATCH] arm64: dts: imx8mm-evk: add pwm1/backlight support

[Tommaso Merciai]

On Wed, Apr 13, 2022 at 12:28:00PM +0200, Krzysztof Kozlowski wrote:
> On 13/04/2022 12:20, Tommaso Merciai wrote:
> > Add pwm1/backlight support nodes for imx8mm_evk board. Align with u-boot
> > dts
> > 
> > References:
> >  - https://patchwork.ozlabs.org/project/uboot/patch/20220326111911.13720-9-tommaso.merciai@amarulasolutions.com/
> > 
> > Signed-off-by: Tommaso Merciai <tommaso.merciai at amarulasolutions.com>
> > ---
> >  arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi | 21 +++++++++++++++++++
> >  1 file changed, 21 insertions(+)
> > 
> > diff --git a/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi b/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi
> > index 6d67df7692f1..55566708f667 100644
> > --- a/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi
> > +++ b/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi
> > @@ -59,6 +59,15 @@ reg_usdhc2_vmmc: regulator-usdhc2 {
> >  		enable-active-high;
> >  	};
> >  
> > +	backlight: backlight {
> > +		status = "disabled";
> 
> Why disabled?
> 
> > +		compatible = "pwm-backlight";
> > +		pwms = <&pwm1 0 5000000>;
> > +		brightness-levels = <0 255>;
> > +		num-interpolated-steps = <255>;
> > +		default-brightness-level = <250>;
> > +	};
> > +
> >  	ir-receiver {
> >  		compatible = "gpio-ir-receiver";
> >  		gpios = <&gpio1 13 GPIO_ACTIVE_LOW>;
> > @@ -395,6 +404,12 @@ &wdog1 {
> >  	status = "okay";
> >  };
> >  
> > +&pwm1 {
> > +	pinctrl-names = "default";
> > +	pinctrl-0 = <&pinctrl_backlight>;
> > +	status = "disabled";
> 
> Same here.
> 
> 
> Best regards,
> Krzysztof

Hi Krzysztof,
I think is better to keep disable into .dtsi and enable it at .dts
level.
What do you think about?

Regards,
Tommaso
-- 
Tommaso Merciai
Embedded Linux Engineer
tommaso.merciai at amarulasolutions.com
__________________________________

Amarula Solutions SRL
Via Le Canevare 30, 31100 Treviso, Veneto, IT
T. +39 042 243 5310
info at amarulasolutions.com
www.amarulasolutions.com