[PATCH] arm64: dts: imx8mm-evk: add pwm1/backlight support

[Krzysztof Kozlowski]

On 13/04/2022 12:20, Tommaso Merciai wrote:
> Add pwm1/backlight support nodes for imx8mm_evk board. Align with u-boot
> dts
> 
> References:
>  - https://patchwork.ozlabs.org/project/uboot/patch/20220326111911.13720-9-tommaso.merciai@amarulasolutions.com/
> 
> Signed-off-by: Tommaso Merciai <tommaso.merciai at amarulasolutions.com>
> ---
>  arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi | 21 +++++++++++++++++++
>  1 file changed, 21 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi b/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi
> index 6d67df7692f1..55566708f667 100644
> --- a/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi
> +++ b/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi
> @@ -59,6 +59,15 @@ reg_usdhc2_vmmc: regulator-usdhc2 {
>  		enable-active-high;
>  	};
>  
> +	backlight: backlight {
> +		status = "disabled";

Why disabled?

> +		compatible = "pwm-backlight";
> +		pwms = <&pwm1 0 5000000>;
> +		brightness-levels = <0 255>;
> +		num-interpolated-steps = <255>;
> +		default-brightness-level = <250>;
> +	};
> +
>  	ir-receiver {
>  		compatible = "gpio-ir-receiver";
>  		gpios = <&gpio1 13 GPIO_ACTIVE_LOW>;
> @@ -395,6 +404,12 @@ &wdog1 {
>  	status = "okay";
>  };
>  
> +&pwm1 {
> +	pinctrl-names = "default";
> +	pinctrl-0 = <&pinctrl_backlight>;
> +	status = "disabled";

Same here.


Best regards,
Krzysztof