[PATCH 1/3] dt-bindings: imx6q-pcie: specify the imx8mq pcie phy voltage

[Lucas Stach]

Am Freitag, dem 19.03.2021 um 16:24 +0800 schrieb Richard Zhu:
> Both 1.8v and 3.3v power supplies can be feeded to i.MX8MQ PCIe PHY.
> In default, the PCIE_VPH voltage is suggested to be 1.8v refer to data
> sheet. When PCIE_VPH is supplied by 3.3v in the HW schematic design,
> the VREG_BYPASS bits of GPR registers should be cleared from default
> value 1b'1 to 1b'0.
> 
> Signed-off-by: Richard Zhu <hongxing.zhu at nxp.com>
> ---
>  Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.txt | 4 ++++
>  1 file changed, 4 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.txt b/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.txt
> index de4b2baf91e8..23efbad9e804 100644
> --- a/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.txt
> +++ b/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.txt
> @@ -59,6 +59,10 @@ Additional required properties for imx7d-pcie and imx8mq-pcie:
>  Additional required properties for imx8mq-pcie:
>  - clock-names: Must include the following additional entries:
>  	- "pcie_aux"
> +- pcie-vph-3v3: If present then PCIE_VPH is feeded by 3.3v in the HW
> +  schematic design. The PCIE_VPH is suggested to be 1.8v refer to the
> +  data sheet. If the PCIE_VPH is supplied by 3.3V, the VREG_BYPASS
> +  should be cleared to zero accordingly.

Uhm, no. Please don't add boolean DT properties for random parts of the
board design.

If we need to know the voltage of PCIE_VPH, we should really add the
VPH regulator as a supply to the PCIe controller node, then work out
the voltage the usual way by using the Linux regulator API.

Regards,
Lucas