[PATCH v2 0/4] enable flexspi support on imx8mp

[Shawn Guo]

On Mon, Mar 15, 2021 at 08:10:37AM +0100, Heiko Schocher wrote:
> Hello Shawn,
> 
> On 15.03.21 07:47, Shawn Guo wrote:
> > On Tue, Mar 09, 2021 at 06:31:12AM +0100, Heiko Schocher wrote:
> >>
> >> This series enables support for the SPI NOR on the
> >> imx8mp based phyboard-pollux-rdk board.
> >>
> >> Patches new in v2:
> >> "spi: fspi: enable fspi driver for on imx8mp"
> >> which adds own compatible entry for imx8mp
> >>
> >> and seperate in own patch the documentation entry in
> >> patch "dt-bindings: spi: add compatible entry for imx8mp in FlexSPI controller"
> >> as checkpatch says:
> >>
> >> warning: DT binding docs and includes should be a separate patch. See: Documentation/devicetree/bindings/submitting-patches.rst
> >>
> >>
> >> Changes in v2:
> >> - work in comments from Marco
> >>   add own compatible entry for imx8mp
> >> - work in comments from Marco
> >>   - add own compatible entry "nxp,imx8mp-fspi"
> >>   - reworked order of properties as Marco mentioned
> >> - work in comments from Marco and Teresa
> >>   - rename node into "'som_flash: flash at 0 { }"
> >>   - compatible is now first entry
> >>   - removed #size-cells and #address-cells
> >>     as no child node. If bootloader adds them bootloader
> >>     can add them too.
> >>
> >> Heiko Schocher (4):
> >>   spi: fspi: enable fspi driver for on imx8mp
> >>   dt-bindings: spi: add compatible entry for imx8mp in FlexSPI
> >>     controller
> >>   arm64: dts: imx8mp: add flexspi node
> >>   arm64: imx8mp: imx8mp-phycore-som enable spi nor
> > 
> > Two DTS patch look good.  Ping me when driver and bindings changes are
> > accepted.
> 
> Thanks!
> 
> Hmm.. I have not splitted this series into 2 series... should I do
> this now?

No, you do not need to.  I sent the message only because I didn't
receive patch #1 and #2, so I will not be aware of their status.

Shawn