[PATCH] arm64: dts: imx8mq-evk: add one regulator used to power up pcie phy

[Shawn Guo]

On Mon, Mar 29, 2021 at 04:06:03PM +0800, Richard Zhu wrote:
> Both 1.8v and 3.3v power supplies can be used by i.MX8MQ PCIe PHY.
> In default, the PCIE_VPH voltage is suggested to be 1.8v refer to data
> sheet. When PCIE_VPH is supplied by 3.3v in the HW schematic design,
> the VREG_BYPASS bits of GPR registers should be cleared from default
> value 1b'1 to 1b'0. Thus, the internal 3v3 to 1v8 translator would be
> turned on.
> 
> Signed-off-by: Richard Zhu <hongxing.zhu at nxp.com>
> Reviewed-by: Lucas Stach <l.stach at pengutronix.de>
> ---
>  arch/arm64/boot/dts/freescale/imx8mq-evk.dts | 1 +
>  1 file changed, 1 insertion(+)
> 
> diff --git a/arch/arm64/boot/dts/freescale/imx8mq-evk.dts b/arch/arm64/boot/dts/freescale/imx8mq-evk.dts
> index 85b045253a0e..4d2035e3dd7c 100644
> --- a/arch/arm64/boot/dts/freescale/imx8mq-evk.dts
> +++ b/arch/arm64/boot/dts/freescale/imx8mq-evk.dts
> @@ -318,6 +318,7 @@
>  		 <&clk IMX8MQ_CLK_PCIE1_PHY>,
>  		 <&pcie0_refclk>;
>  	clock-names = "pcie", "pcie_aux", "pcie_phy", "pcie_bus";
> +	vph-supply = <&vgen5_reg>;

Hmm, I do not see this in the bindings doc.

Shawn

>  	status = "okay";
>  };
>  
> -- 
> 2.17.1
>