[PATCH] arm64: dts: imx8mq-evk: add one regulator used to power up pcie phy

[Richard Zhu]

Hi Shawn:
Regarding Lucas' advice, this patch should be split out and post for you to pick up into DT tree.
Since the other two patches are accepted by PCIe tree now.
Can you help to pick up this patch?
Thanks in advanced.
https://patchwork.kernel.org/project/linux-pci/patch/1616661882-26487-3-git-send-email-hongxing.zhu@nxp.com/
https://patchwork.kernel.org/project/linux-pci/patch/1617091701-6444-2-git-send-email-hongxing.zhu@nxp.com/

Best Regards
Richard Zhu

> -----Original Message-----
> From: Richard Zhu <hongxing.zhu at nxp.com>
> Sent: Wednesday, April 14, 2021 10:26 AM
> To: shawnguo at kernel.org
> Cc: l.stach at pengutronix.de; dl-linux-imx <linux-imx at nxp.com>;
> linux-arm-kernel at lists.infradead.org; linux-kernel at vger.kernel.org; Richard
> Zhu <hongxing.zhu at nxp.com>
> Subject: [PATCH] arm64: dts: imx8mq-evk: add one regulator used to power
> up pcie phy
> 
> Both 1.8v and 3.3v power supplies can be used by i.MX8MQ PCIe PHY.
> In default, the PCIE_VPH voltage is suggested to be 1.8v refer to data sheet.
> When PCIE_VPH is supplied by 3.3v in the HW schematic design, the
> VREG_BYPASS bits of GPR registers should be cleared from default value 1b'1
> to 1b'0. Thus, the internal 3v3 to 1v8 translator would be turned on.
> 
> Signed-off-by: Richard Zhu <hongxing.zhu at nxp.com>
> Reviewed-by: Lucas Stach <l.stach at pengutronix.de>
> ---
>  arch/arm64/boot/dts/freescale/imx8mq-evk.dts | 1 +
>  1 file changed, 1 insertion(+)
> 
> diff --git a/arch/arm64/boot/dts/freescale/imx8mq-evk.dts
> b/arch/arm64/boot/dts/freescale/imx8mq-evk.dts
> index 85b045253a0e..4d2035e3dd7c 100644
> --- a/arch/arm64/boot/dts/freescale/imx8mq-evk.dts
> +++ b/arch/arm64/boot/dts/freescale/imx8mq-evk.dts
> @@ -318,6 +318,7 @@
>  		 <&clk IMX8MQ_CLK_PCIE1_PHY>,
>  		 <&pcie0_refclk>;
>  	clock-names = "pcie", "pcie_aux", "pcie_phy", "pcie_bus";
> +	vph-supply = <&vgen5_reg>;
>  	status = "okay";
>  };
> 
> --
> 2.17.1