[PATCH 10/11] arm64: dts: hisilicon: list all clocks required by pl011.yaml

[Zhen Lei]

The arm,pl011 binding need to specify two clocks: "uartclk", "apb_pclk".
But only "apb_pclk" is specified now. Because the driver preferentially
matches the first clock. Otherwise, it matches the second clock instead
of both clocks. So both of them use the same clock don't change the
function.

Signed-off-by: Zhen Lei <thunder.leizhen at huawei.com>
---
 arch/arm64/boot/dts/hisilicon/hi3798cv200.dtsi | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/arch/arm64/boot/dts/hisilicon/hi3798cv200.dtsi b/arch/arm64/boot/dts/hisilicon/hi3798cv200.dtsi
index 1c7dda972c92856..81d09434c5c610d 100644
--- a/arch/arm64/boot/dts/hisilicon/hi3798cv200.dtsi
+++ b/arch/arm64/boot/dts/hisilicon/hi3798cv200.dtsi
@@ -216,8 +216,8 @@
 			compatible = "arm,pl011", "arm,primecell";
 			reg = <0x8b00000 0x1000>;
 			interrupts = <GIC_SPI 49 IRQ_TYPE_LEVEL_HIGH>;
-			clocks = <&sysctrl HISTB_UART0_CLK>;
-			clock-names = "apb_pclk";
+			clocks = <&sysctrl HISTB_UART0_CLK>, <&sysctrl HISTB_UART0_CLK>;
+			clock-names = "uartclk", "apb_pclk";
 			status = "disabled";
 		};
 
@@ -225,8 +225,8 @@
 			compatible = "arm,pl011", "arm,primecell";
 			reg = <0x8b02000 0x1000>;
 			interrupts = <GIC_SPI 51 IRQ_TYPE_LEVEL_HIGH>;
-			clocks = <&crg HISTB_UART2_CLK>;
-			clock-names = "apb_pclk";
+			clocks = <&crg HISTB_UART2_CLK>, <&crg HISTB_UART2_CLK>;
+			clock-names = "uartclk", "apb_pclk";
 			status = "disabled";
 		};
 
-- 
1.8.3