[PATCH 0/8] Add support for UHS modes in TI's J721e and J7200 boards

[Faiz Abbas]

The following patches add support for UHS modes for TI's j721e and j7200
boards.

Patches 1-3 add support for gpios to j7200-evm

Patches 4-6 add support for voltage regulators for required by the
SD card in both devices as well as enable UHS modes at 1.8V

Patches 5-6 add some required configs to the arm64 defconfig.

This series depends on driver patches adding tuning support here:
https://lore.kernel.org/linux-arm-kernel/20200923105206.7988-1-faiz_abbas@ti.com/

Faiz Abbas (8):
  arm64: dts: ti: k3-j7200-main: Add gpio nodes in main domain
  arm64: dts: ti: k3-j7200: Add gpio nodes in wakeup domain
  arm64: dts: ti: k3-j7200-common-proc-board: Disable unused gpio
    modules
  arm64: dts: ti: k3-j721e-main: Add output tap delay values
  arm64: dts: ti: k3-j721e-common-proc-board: Add support SD card UHS
    modes
  arm64: dts: ti: k3-j7200-common-proc-board: Add support SD card UHS
    modes
  arm64: defconfig: Enable OMAP I2C driver
  arm64: defconfig: Enable DAVINCI_GPIO driver

 .../dts/ti/k3-j7200-common-proc-board.dts     | 48 +++++++++++++
 arch/arm64/boot/dts/ti/k3-j7200-main.dtsi     | 69 ++++++++++++++++++-
 .../boot/dts/ti/k3-j7200-mcu-wakeup.dtsi      | 32 +++++++++
 .../dts/ti/k3-j721e-common-proc-board.dts     | 35 +++++++++-
 arch/arm64/boot/dts/ti/k3-j721e-main.dtsi     | 22 ++++--
 arch/arm64/configs/defconfig                  |  2 +
 6 files changed, 201 insertions(+), 7 deletions(-)

-- 
2.17.1