[PATCH 15/21] iommu/mediatek: Support master use iova over 32bit

Yong Wu yong.wu at mediatek.com
Sat Jul 11 02:48:40 EDT 2020


After extending v7s, our pagetable already support iova reach
16GB(34bit). the master got the iova via dma_alloc_attrs may reach
34bits, but its HW register still is 32bit. then how to set the
bit32/bit33 iova? this depend on a SMI larb setting(bank_sel).

we separate whole 16GB iova to four banks:
bank: 0: 0~4G; 1: 4~8G; 2: 8-12G; 3: 12-16G;
The bank number is (iova >> 32).

We will preassign which bank the larbs belong to. currently we don't
have a interface for master to adjust its bank number.

Each a bank is a iova_region which is a independent iommu-domain.
the iova range for each iommu-domain can't cross 4G.

Signed-off-by: Yong Wu <yong.wu at mediatek.com>
---
 drivers/iommu/mtk_iommu.c  | 12 +++++++++---
 drivers/memory/mtk-smi.c   |  5 +++++
 include/soc/mediatek/smi.h |  1 +
 3 files changed, 15 insertions(+), 3 deletions(-)

diff --git a/drivers/iommu/mtk_iommu.c b/drivers/iommu/mtk_iommu.c
index db1f06324ecc..3b2714bea45a 100644
--- a/drivers/iommu/mtk_iommu.c
+++ b/drivers/iommu/mtk_iommu.c
@@ -315,17 +315,23 @@ static void mtk_iommu_config(struct mtk_iommu_data *data,
 			     struct device *dev, bool enable)
 {
 	struct mtk_smi_larb_iommu    *larb_mmu;
-	unsigned int                 larbid, portid;
+	unsigned int                 larbid, portid, domid;
 	struct iommu_fwspec *fwspec = dev_iommu_fwspec_get(dev);
+	const struct mtk_iommu_iova_region *region;
 	int i;
 
 	for (i = 0; i < fwspec->num_ids; ++i) {
 		larbid = MTK_M4U_TO_LARB(fwspec->ids[i]);
 		portid = MTK_M4U_TO_PORT(fwspec->ids[i]);
+		domid = MTK_M4U_TO_DOM(fwspec->ids[i]);
+
 		larb_mmu = &data->larb_imu[larbid];
+		region = data->plat_data->iova_region + domid;
+		larb_mmu->bank[portid] = upper_32_bits(region->iova_base);
 
-		dev_dbg(dev, "%s iommu port: %d\n",
-			enable ? "enable" : "disable", portid);
+		dev_dbg(dev, "%s iommu for larb(%s) port %d dom %d bank %d.\n",
+			enable ? "enable" : "disable", dev_name(larb_mmu->dev),
+			portid, domid, larb_mmu->bank[portid]);
 
 		if (enable)
 			larb_mmu->mmu |= MTK_SMI_MMU_EN(portid);
diff --git a/drivers/memory/mtk-smi.c b/drivers/memory/mtk-smi.c
index f6516921287f..f2f6100c74ef 100644
--- a/drivers/memory/mtk-smi.c
+++ b/drivers/memory/mtk-smi.c
@@ -41,6 +41,8 @@
 /* mt2712 */
 #define SMI_LARB_NONSEC_CON(id)	(0x380 + ((id) * 4))
 #define F_MMU_EN		BIT(0)
+#define BANK_SEL(a)		((((a) & 0x3) << 8) | (((a) & 0x3) << 10) |\
+				 (((a) & 0x3) << 12) | (((a) & 0x3) << 14))
 
 /* SMI COMMON */
 #define SMI_BUS_SEL			0x220
@@ -85,6 +87,7 @@ struct mtk_smi_larb { /* larb: local arbiter */
 	const struct mtk_smi_larb_gen	*larb_gen;
 	int				larbid;
 	u32				*mmu;
+	unsigned char			*bank;
 };
 
 static int mtk_smi_clk_enable(const struct mtk_smi *smi)
@@ -151,6 +154,7 @@ mtk_smi_larb_bind(struct device *dev, struct device *master, void *data)
 		if (dev == larb_mmu[i].dev) {
 			larb->larbid = i;
 			larb->mmu = &larb_mmu[i].mmu;
+			larb->bank = larb_mmu[i].bank;
 			return 0;
 		}
 	}
@@ -169,6 +173,7 @@ static void mtk_smi_larb_config_port_gen2_general(struct device *dev)
 	for_each_set_bit(i, (unsigned long *)larb->mmu, 32) {
 		reg = readl_relaxed(larb->base + SMI_LARB_NONSEC_CON(i));
 		reg |= F_MMU_EN;
+		reg |= BANK_SEL(larb->bank[i]);
 		writel(reg, larb->base + SMI_LARB_NONSEC_CON(i));
 	}
 }
diff --git a/include/soc/mediatek/smi.h b/include/soc/mediatek/smi.h
index 9371bf572ab8..4cf445dbbdaa 100644
--- a/include/soc/mediatek/smi.h
+++ b/include/soc/mediatek/smi.h
@@ -16,6 +16,7 @@
 struct mtk_smi_larb_iommu {
 	struct device *dev;
 	unsigned int   mmu;
+	unsigned char  bank[32];
 };
 
 /*
-- 
2.18.0


More information about the linux-arm-kernel mailing list