[PATCH v6 00/13] Add support for PinePhone LCD panel

[Linus Walleij]

On Wed, Jul 1, 2020 at 6:30 PM Ondřej Jirman <megous at megous.com> wrote:
> On Wed, Jul 01, 2020 at 05:25:32PM +0200, Sam Ravnborg wrote:
> > Hi Ondrej.
> >
> > On Wed, Jul 01, 2020 at 12:31:13PM +0200, Ondrej Jirman wrote:
> > > This patchset adds support for the LCD panel of PinePhone.
> > >
> > > I've tested this on PinePhone 1.0 and 1.2.
> > >
> > > Please take a look.
> > >
> > > thank you and regards,
> > >   Ondrej Jirman
> > >
> > > Changes in v6:
> > > - Fixed spacing in yaml
> > > - Fixed wrong vccio->iovcc supply name in the bindings doc
> > > - I noticed that the original driver uses a delay of 20ms in the init
> > >   function to achieve a combined total of 120ms required from post-reset
> > >   to display_on. I've added a similar delay to xbd599_init, so that
> > >   xbd599 panel also has the right timing. (patch 9)
> > > - v5->v6 diff: https://megous.com/dl/tmp/v5-v6.patch
> > > - Added review/ack tags
> > > - Learned to run dt_binding_check by myself ;)
> > The patch-set does not apply clean on top of drm-misc-next - due to
> > vrefresh removal.
> > Please re-spin.
>
> Sorry for that. Rebased and retested.

Sam will you apply it? I was in the middle of applying and ran into the same
issue :D

Yours,
Linus Walleij