[RFC please help] membarrier: Rewrite sync_core_before_usermode()

[Russell King - ARM Linux admin]

On Mon, Dec 28, 2020 at 07:29:34PM +0100, Jann Horn wrote:
> After chatting with rmk about this (but without claiming that any of
> this is his opinion), based on the manpage, I think membarrier()
> currently doesn't really claim to be synchronizing caches? It just
> serializes cores. So arguably if userspace wants to use membarrier()
> to synchronize code changes, userspace should first do the code
> change, then flush icache as appropriate for the architecture, and
> then do the membarrier() to ensure that the old code is unused?
> 
> For 32-bit arm, rmk pointed out that that would be the cacheflush()
> syscall. That might cause you to end up with two IPIs instead of one
> in total, but we probably don't care _that_ much about extra IPIs on
> 32-bit arm?
> 
> For arm64, I believe userspace can flush icache across the entire
> system with some instructions from userspace - "DC CVAU" followed by
> "DSB ISH", or something like that, I think? (See e.g.
> compat_arm_syscall(), the arm64 compat code that implements the 32-bit
> arm cacheflush() syscall.)

Note that the ARM cacheflush syscall calls flush_icache_user_range()
over the range of addresses that userspace has passed - it's intention
since day one is to support cases where userspace wants to change
executable code.

It will issue the appropriate write-backs to the data cache (DCCMVAU),
the invalidates to the instruction cache (ICIMVAU), invalidate the
branch target buffer (BPIALLIS or BPIALL as appropriate), and issue
the appropriate barriers (DSB ISHST, ISB).

Note that neither flush_icache_user_range() nor flush_icache_range()
result in IPIs; cache operations are broadcast across all CPUs (which
is one of the minimums we require for SMP systems.)

Now, that all said, I think the question that has to be asked is...

	What is the basic purpose of membarrier?

Is the purpose of it to provide memory barriers, or is it to provide
memory coherence?

If it's the former and not the latter, then cache flushes are out of
scope, and expecting memory written to be visible to the instruction
stream is totally out of scope of the membarrier interface, whether
or not the writes happen on the same or a different CPU to the one
executing the rewritten code.

The documentation in the kernel does not seem to describe what it's
supposed to be doing - the only thing I could find is this:
Documentation/features/sched/membarrier-sync-core/arch-support.txt
which describes it as "arch supports core serializing membarrier"
whatever that means.

Seems to be the standard and usual case of utterly poor to non-existent
documentation within the kernel tree, or even a pointer to where any
useful documentation can be found.

Reading the membarrier(2) man page, I find nothing in there that talks
about any kind of cache coherency for self-modifying code - it only
seems to be about _barriers_ and nothing more, and barriers alone do
precisely nothing to save you from non-coherent Harvard caches.

So, either Andy has a misunderstanding, or the man page is wrong, or
my rudimentary understanding of what membarrier is supposed to be
doing is wrong...

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 40Mbps down 10Mbps up. Decent connectivity at last!