[PATCH v3 1/2] arm64: dts: meson-g12b-odroid-n2: Enable RTC controller node

[Anand Moon]

hi All,

On Fri, 21 Aug 2020 at 10:13, Anand Moon <linux.amoon at gmail.com> wrote:
>
> Hi Kevin,
>
> Thanks for your review comments.
>
> On Fri, 21 Aug 2020 at 01:03, Kevin Hilman <khilman at baylibre.com> wrote:
> >
> > Anand Moon <linux.amoon at gmail.com> writes:
> >
> > > Enable RTC PCF8563 node on Odroid-N2 SBC, In order to
> > > support the RTC wakealarm feature for suspend and resume.
> > > Also assign an alias to the pcf8563 to rtc0 and meson-vrtc to rtc1
> > > timer device to prevent it being assigned to /dev/rtc0
> > > which disto userspace tools assume is a clock device.
> > >
> > > Cc: Neil Armstrong <narmstrong at baylibre.com>
> > > Cc: Kevin Hilman <khilman at baylibre.com>
> > > Suggested-by: Christian Hewitt <christianshewitt at gmail.com>
> > > Signed-off-by: Anand Moon <linux.amoon at gmail.com>
> > > ---
> > > Changes V3
> > > --Drop the INI GPIOAO.BIT7 pinctrl.
> >
> > Why did you drop this GPIO?  Isn't this the GPIO that the RTC uses to
> > wakeup the system?  If so, this should be included as part of this
> > patch.
> >
> > It probably still works because the bootloader configures this GPIO as
> > input, but the kernel should not rely on the booloader for that, so
> > please include as part of this patch.
> >
>
> Ok I will figure out the correct pinctrl need for this settings.
> looking into the Odroid N2 schematics.
>

I am trying to map the RTC INT pinctrl, ie RTC INT GPIOAO.BIT7.

So from the schematics it is seen below.
RTC INT  GPIOAO_7 (AV46)   GPIOAO_7 (JTAG_A_TMS // TSIN_A_DIN0 //
TDMB_FS // TDMB_SLV_FS)

But the S922X datasheet this pin *AV46* shows to following settings,
AN16    DVSS    AV46      GPIOAO_7    BD19    BOOT_11

>From the schematics it BOOT_11 is linked to
              BOOT_11 (NAND_CE0)      BD19

So can I conclude that BOOT_11 (nand_ce0_pins) pin linked to the RTC INT setting
Please can somebody help me with correct pinctrl settings.

Best Regards
-Anand Moon