[PATCH] mmc: sdhci-of-arasan: Add quirk to avoid erroneous msg

[Shawn Lin]

在 2018/2/27 21:55, Phil Edworthy 写道:
> Since the controller does not support the end-of-busy IRQ, don't use it.
> Otherwise, on older SD cards you will get lots of these messages:
> "mmc0: Got data interrupt 0x00000002 even though no data operation was in progress"
> 

I'm afraid you have to explain which version of arasan's IP suffer from
this and what does the "older SD cards" mean?

> This has been reported on Xilinx devices that also use the Arasan IP.
> See https://patchwork.kernel.org/patch/8062871/
> 
> This has been tested on the Renesas RZ/ND-DB board with the RZ/N1 SoC.
> 
> Signed-off-by: Phil Edworthy <phil.edworthy at renesas.com>
> ---
>   drivers/mmc/host/sdhci-of-arasan.c | 3 ++-
>   1 file changed, 2 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/mmc/host/sdhci-of-arasan.c b/drivers/mmc/host/sdhci-of-arasan.c
> index c33a5f7..ab66e32 100644
> --- a/drivers/mmc/host/sdhci-of-arasan.c
> +++ b/drivers/mmc/host/sdhci-of-arasan.c
> @@ -290,7 +290,8 @@ static const struct sdhci_pltfm_data sdhci_arasan_pdata = {
>   	.ops = &sdhci_arasan_ops,
>   	.quirks = SDHCI_QUIRK_CAP_CLOCK_BASE_BROKEN,
>   	.quirks2 = SDHCI_QUIRK2_PRESET_VALUE_BROKEN |
> -			SDHCI_QUIRK2_CLOCK_DIV_ZERO_BROKEN,
> +			SDHCI_QUIRK2_CLOCK_DIV_ZERO_BROKEN |
> +			SDHCI_QUIRK2_STOP_WITH_TC,
>   };
>   
>   static u32 sdhci_arasan_cqhci_irq(struct sdhci_host *host, u32 intmask)
> 


-- 
Best Regards
Shawn Lin