[linux-sunxi] [PATCH v3] ARM: sun8i: h2+: add support for Banana Pi M2 Zero board

[Icenowy Zheng]

于 2018年2月5日 GMT+08:00 下午9:36:25, Maxime Ripard <maxime.ripard at bootlin.com> 写到:
>On Sat, Feb 03, 2018 at 05:45:52PM +1100, Julian Calaby wrote:
>> Hi all,
>> 
>> On Sun, Dec 24, 2017 at 4:40 PM, Icenowy Zheng <icenowy at aosc.io>
>wrote:
>> > Banana Pi M2 Zero board is a H2+-based board by Sinovoip, with a
>form
>> > factor and GPIO holes similar to Raspberry Pi Zero.
>> >
>> > It features:
>> > - Allwinner H2+ SoC
>> > - Single-chip (16-bit) 512MiB DDR3 DRAM
>> > - Ampak AP6212 Wi-Fi/Bluetooth module
>> > - MicroSD slot
>> > - Two MicroUSB Type-B ports (one can only be used to power the
>board and
>> >   the other features OTG functionality)
>> > - Two keys, a reset and a GPIO-connected key.
>> > - HDMI Type-C (miniHDMI) connector connected to the HDMI part of
>H2+.
>> > - CSI connector to connect the camera sensor provided by Sinovoip.
>> >
>> > Signed-off-by: Icenowy Zheng <icenowy at aosc.io>
>> 
>> [Trimmed lots of non-sunxi-specific mailing lists]
>> 
>> Did support for this board ever get merged?
>
>It doesn't look like it did.

Is there any problem in this patch now except the
absense of SPDX license usage?

>
>> (I have two of them now, so if it didn't, I'll try to shepherd this
>> and it's corresponding u-boot patch upstream.)
>
>That sounds great :)
>
>Maxime