[linux-sunxi] [PATCH v3] ARM: sun8i: h2+: add support for Banana Pi M2 Zero board

[Maxime Ripard]

On Sat, Feb 03, 2018 at 05:45:52PM +1100, Julian Calaby wrote:
> Hi all,
> 
> On Sun, Dec 24, 2017 at 4:40 PM, Icenowy Zheng <icenowy at aosc.io> wrote:
> > Banana Pi M2 Zero board is a H2+-based board by Sinovoip, with a form
> > factor and GPIO holes similar to Raspberry Pi Zero.
> >
> > It features:
> > - Allwinner H2+ SoC
> > - Single-chip (16-bit) 512MiB DDR3 DRAM
> > - Ampak AP6212 Wi-Fi/Bluetooth module
> > - MicroSD slot
> > - Two MicroUSB Type-B ports (one can only be used to power the board and
> >   the other features OTG functionality)
> > - Two keys, a reset and a GPIO-connected key.
> > - HDMI Type-C (miniHDMI) connector connected to the HDMI part of H2+.
> > - CSI connector to connect the camera sensor provided by Sinovoip.
> >
> > Signed-off-by: Icenowy Zheng <icenowy at aosc.io>
> 
> [Trimmed lots of non-sunxi-specific mailing lists]
> 
> Did support for this board ever get merged?

It doesn't look like it did.

> (I have two of them now, so if it didn't, I'll try to shepherd this
> and it's corresponding u-boot patch upstream.)

That sounds great :)

Maxime

-- 
Maxime Ripard, Bootlin (formerly Free Electrons)
Embedded Linux and Kernel engineering
http://bootlin.com
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 833 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20180205/3779c95c/attachment.sig>