[PATCH v2 8/9] atmel_flexcom: Support backup mode

Romain Izard romain.izard.pro at gmail.com
Wed Sep 20 01:30:31 PDT 2017


2017-09-19 17:25 GMT+02:00 Lee Jones <lee.jones at linaro.org>:
> On Tue, 19 Sep 2017, Nicolas Ferre wrote:
>
>> On 15/09/2017 at 16:04, Romain Izard wrote:
>> > The controller used by a flexcom module is configured at boot, and left
>> > alone after this. As the configuration will be lost after backup mode,
>> > restore the state of the flexcom driver on resume.
>> >
>> > Signed-off-by: Romain Izard <romain.izard.pro at gmail.com>
>>
>> Tested-by: Nicolas Ferre <nicolas.ferre at microchip.com>
>> On sama5d2 Xplained board (i2c0 from flexcom 4).
>> and obviously:
>> Acked-by: Nicolas Ferre <nicolas.ferre at microchip.com>
>>
>> Thanks Romain!
>>
>> Regards,
>>
>> > ---
>> >  drivers/mfd/atmel-flexcom.c | 65 ++++++++++++++++++++++++++++++++++-----------
>> >  1 file changed, 50 insertions(+), 15 deletions(-)
>
> This is the first time I've seen this patch.  Why's that?
>

As the patchset covers many subsystems, get_maintainers.pl provided a
very long list of both developpers and mailing lists (28). I thought it
was a good idea to shorten it a little. Bad idea. Sorry.

Best regards,
-- 
Romain Izard



More information about the linux-arm-kernel mailing list