[PATCH v2 8/9] atmel_flexcom: Support backup mode
Lee Jones
lee.jones at linaro.org
Tue Sep 19 08:25:04 PDT 2017
On Tue, 19 Sep 2017, Nicolas Ferre wrote:
> On 15/09/2017 at 16:04, Romain Izard wrote:
> > The controller used by a flexcom module is configured at boot, and left
> > alone after this. As the configuration will be lost after backup mode,
> > restore the state of the flexcom driver on resume.
> >
> > Signed-off-by: Romain Izard <romain.izard.pro at gmail.com>
>
> Tested-by: Nicolas Ferre <nicolas.ferre at microchip.com>
> On sama5d2 Xplained board (i2c0 from flexcom 4).
> and obviously:
> Acked-by: Nicolas Ferre <nicolas.ferre at microchip.com>
>
> Thanks Romain!
>
> Regards,
>
> > ---
> > drivers/mfd/atmel-flexcom.c | 65 ++++++++++++++++++++++++++++++++++-----------
> > 1 file changed, 50 insertions(+), 15 deletions(-)
This is the first time I've seen this patch. Why's that?
--
Lee Jones
Linaro STMicroelectronics Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog
More information about the linux-arm-kernel
mailing list