[PATCH 1/2] pinctrl: armada-37xx: Fix uart2 group selection register mask

[Gregory CLEMENT]

From: Ken Ma <make at marvell.com>

If north bridge selection register bit1 is clear, pins [10:8] are for
SDIO0 Resetn, Wakeup, and PDN while if bit1 is set, pins [10:8]are for
GPIO; when bit1 is clear, pin 9 and pin 10 can be used for uart2 RTSn
and CTSn, so bit1 should be added to uart2 group and it must be set
for both "gpio" and "uart" functions of uart2 group.

Signed-off-by: Ken Ma <make at marvell.com>
Signed-off-by: Gregory CLEMENT <gregory.clement at free-electrons.com>
---
 drivers/pinctrl/mvebu/pinctrl-armada-37xx.c | 5 +++--
 1 file changed, 3 insertions(+), 2 deletions(-)

diff --git a/drivers/pinctrl/mvebu/pinctrl-armada-37xx.c b/drivers/pinctrl/mvebu/pinctrl-armada-37xx.c
index 5c96f5558310..2fb1c67886fc 100644
--- a/drivers/pinctrl/mvebu/pinctrl-armada-37xx.c
+++ b/drivers/pinctrl/mvebu/pinctrl-armada-37xx.c
@@ -147,8 +147,9 @@ static struct armada_37xx_pin_group armada_37xx_nb_groups[] = {
 	PIN_GRP_GPIO("onewire", 4, 1, BIT(16), "onewire"),
 	PIN_GRP_GPIO("uart1", 25, 2, BIT(17), "uart"),
 	PIN_GRP_GPIO("spi_quad", 15, 2, BIT(18), "spi"),
-	PIN_GRP_EXTRA("uart2", 9, 2, BIT(13) | BIT(14) | BIT(19),
-		      BIT(13) | BIT(14), BIT(19), 18, 2, "gpio", "uart"),
+	PIN_GRP_EXTRA("uart2", 9, 2, BIT(1) | BIT(13) | BIT(14) | BIT(19),
+		      BIT(1) | BIT(13) | BIT(14), BIT(1) | BIT(19),
+		      18, 2, "gpio", "uart"),
 	PIN_GRP_GPIO("led0_od", 11, 1, BIT(20), "led"),
 	PIN_GRP_GPIO("led1_od", 12, 1, BIT(21), "led"),
 	PIN_GRP_GPIO("led2_od", 13, 1, BIT(22), "led"),
-- 
2.11.0