[PATCH v5 1/4] ARM: dts: at91: sama5d2_xplained: enable ADTRG pin

[Jonathan Cameron]

On Thu, 15 Jun 2017 16:24:54 +0300
Eugen Hristev <eugen.hristev at microchip.com> wrote:

> Enable pinctrl for ADTRG pin (PD31) for ADC hardware trigger support.
> 
> Signed-off-by: Eugen Hristev <eugen.hristev at microchip.com>
> Acked-by: Ludovic Desroches <ludovic.desroches at microchip.com>
The driver changes are on their way upstream.

Acked-by: Jonathan Cameron <jic23 at kernel.org>
> ---
>  arch/arm/boot/dts/at91-sama5d2_xplained.dts | 16 +++++++++++++++-
>  1 file changed, 15 insertions(+), 1 deletion(-)
> 
> diff --git a/arch/arm/boot/dts/at91-sama5d2_xplained.dts b/arch/arm/boot/dts/at91-sama5d2_xplained.dts
> index 0bef9e0..04754b1 100644
> --- a/arch/arm/boot/dts/at91-sama5d2_xplained.dts
> +++ b/arch/arm/boot/dts/at91-sama5d2_xplained.dts
> @@ -303,7 +303,7 @@
>  				vddana-supply = <&vdd_3v3_lp_reg>;
>  				vref-supply = <&vdd_3v3_lp_reg>;
>  				pinctrl-names = "default";
> -				pinctrl-0 = <&pinctrl_adc_default>;
> +				pinctrl-0 = <&pinctrl_adc_default &pinctrl_adtrg_default>;
>  				status = "okay";
>  			};
>  
> @@ -322,6 +322,20 @@
>  					bias-disable;
>  				};
>  
> +				/*
> +				 * The ADTRG pin can work on any edge type.
> +				 * In here it's being pulled up, so need to
> +				 * connect it to ground to get an edge e.g.
> +				 * Trigger can be configured on falling, rise
> +				 * or any edge, and the pull-up can be changed
> +				 * to pull-down or left floating according to
> +				 * needs.
> +				 */
> +				pinctrl_adtrg_default: adtrg_default {
> +					pinmux = <PIN_PD31__ADTRG>;
> +					bias-pull-up;
> +				};
> +
>  				pinctrl_charger_chglev: charger_chglev {
>  					pinmux = <PIN_PA12__GPIO>;
>  					bias-disable;