[PATCH v5 1/4] ARM: dts: at91: sama5d2_xplained: enable ADTRG pin

[Eugen Hristev]

Enable pinctrl for ADTRG pin (PD31) for ADC hardware trigger support.

Signed-off-by: Eugen Hristev <eugen.hristev at microchip.com>
Acked-by: Ludovic Desroches <ludovic.desroches at microchip.com>
---
 arch/arm/boot/dts/at91-sama5d2_xplained.dts | 16 +++++++++++++++-
 1 file changed, 15 insertions(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/at91-sama5d2_xplained.dts b/arch/arm/boot/dts/at91-sama5d2_xplained.dts
index 0bef9e0..04754b1 100644
--- a/arch/arm/boot/dts/at91-sama5d2_xplained.dts
+++ b/arch/arm/boot/dts/at91-sama5d2_xplained.dts
@@ -303,7 +303,7 @@
 				vddana-supply = <&vdd_3v3_lp_reg>;
 				vref-supply = <&vdd_3v3_lp_reg>;
 				pinctrl-names = "default";
-				pinctrl-0 = <&pinctrl_adc_default>;
+				pinctrl-0 = <&pinctrl_adc_default &pinctrl_adtrg_default>;
 				status = "okay";
 			};
 
@@ -322,6 +322,20 @@
 					bias-disable;
 				};
 
+				/*
+				 * The ADTRG pin can work on any edge type.
+				 * In here it's being pulled up, so need to
+				 * connect it to ground to get an edge e.g.
+				 * Trigger can be configured on falling, rise
+				 * or any edge, and the pull-up can be changed
+				 * to pull-down or left floating according to
+				 * needs.
+				 */
+				pinctrl_adtrg_default: adtrg_default {
+					pinmux = <PIN_PD31__ADTRG>;
+					bias-pull-up;
+				};
+
 				pinctrl_charger_chglev: charger_chglev {
 					pinmux = <PIN_PA12__GPIO>;
 					bias-disable;
-- 
2.7.4