[PATCH v1 2/3] dt-bindings: display: panel: Add support for Orise Tech otm8009a dsi panel

[Philippe CORNU]

On 07/10/2017 03:12 AM, Rob Herring wrote:
> On Tue, Jul 04, 2017 at 06:30:04PM +0200, Philippe CORNU wrote:
>> The Orise Tech OTM8009A is a 3.97" 480x800 TFT LCD panel connected using
>> a MIPI-DSI video interface. Its backlight is managed through the DSI link.
>>
>> Signed-off-by: Philippe CORNU <philippe.cornu at st.com>
>> ---
>>   .../bindings/display/panel/orisetech,otm8009a.txt    | 20 ++++++++++++++++++++
>>   1 file changed, 20 insertions(+)
>>   create mode 100644 Documentation/devicetree/bindings/display/panel/orisetech,otm8009a.txt
>>
>> diff --git a/Documentation/devicetree/bindings/display/panel/orisetech,otm8009a.txt b/Documentation/devicetree/bindings/display/panel/orisetech,otm8009a.txt
>> new file mode 100644
>> index 0000000..0bb8237
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/display/panel/orisetech,otm8009a.txt
>> @@ -0,0 +1,20 @@
>> +Orise Tech OTM8009A 3.97" 480x800 TFT LCD panel (MIPI-DSI video mode)
>> +
>> +The Orise Tech OTM8009A is a 3.97" 480x800 TFT LCD panel connected using
>> +a MIPI-DSI video interface. Its backlight is managed through the DSI link.
>> +
>> +Required properties:
>> +  - compatible: "orisetech,otm8009a"
>> +  - reg: the virtual channel number of a DSI peripheral
>> +  - reset-gpios: a GPIO spec for the reset pin (active low). (Optional)
> 
> If this is optional, move it to its own section.
> 

Dear Rob,
Many thanks for your comment. Fixed in v2, sent few minutes ago.
Best regards,
Philippe

>> +
>> +Example:
>> +&dsi {
>> +	...
>> +
>> +	panel at 0 {
>> +		compatible = "orisetech,otm8009a";
>> +		reg = <0>;
>> +		reset-gpios = <&gpioh 7 0>;
>> +	};
>> +};
>> -- 
>> 1.9.1
>>