[PATCH 4/4] ARM: dts: sun8i: add OTG function to Lichee Pi Zero

[Bin Liu]

On Thu, Jan 12, 2017 at 03:55:33AM +0800, Icenowy Zheng wrote:
> 
> 
> 11.01.2017, 04:24, "Bin Liu" <b-liu at ti.com>:
> > On Tue, Jan 03, 2017 at 11:25:34PM +0800, Icenowy Zheng wrote:
> >>  Lichee Pi Zero features a USB OTG port.
> >>
> >>  Add support for it.
> >>
> >>  Note: in order to use the Host mode, the board must be powered via the
> >>  +5V and GND pins.
> >>
> >>  Signed-off-by: Icenowy Zheng <icenowy at aosc.xyz>
> >>  ---
> >>   arch/arm/boot/dts/sun8i-v3s-licheepi-zero.dts | 10 ++++++++++
> >>   1 file changed, 10 insertions(+)
> >>
> >>  diff --git a/arch/arm/boot/dts/sun8i-v3s-licheepi-zero.dts b/arch/arm/boot/dts/sun8i-v3s-licheepi-zero.dts
> >>  index 0099affc6ce3..3d9168cbaeca 100644
> >>  --- a/arch/arm/boot/dts/sun8i-v3s-licheepi-zero.dts
> >>  +++ b/arch/arm/boot/dts/sun8i-v3s-licheepi-zero.dts
> >>  @@ -71,3 +71,13 @@
> >>           pinctrl-names = "default";
> >>           status = "okay";
> >>   };
> >>  +
> >>  +&usb_otg {
> >>  + dr_mode = "otg";
> >
> > Why not set this default mode in dtsi instead?
> >
> > Regards,
> > -Bin.
> 
> There's possibly boards which do not have OTG functions.

That is board specific.

You'd better to define the default dr_mode which the musb _controller_
supports in the dtsi, and then override it in a specific board dts if
necessary.

Regards,
-Bin.

> 
> Even the official CDR design of V3s uses the USB controller to
> connect a UVC webcam to make the design a dual-cam design
> (V3s itself has a CSI).
> 
> >
> >>  + status = "okay";
> >>  +};
> >>  +
> >>  +&usbphy {
> >>  + usb0_id_det-gpio = <&pio 5 6 GPIO_ACTIVE_HIGH>;
> >>  + status = "okay";
> >>  +};
> >>  --
> >>  2.11.0