[PATCH 3/8] ARM: dts: exynos: Fix watchdog reset on Exynos4412

[Krzysztof Kozlowski]

On Fri, Feb 24, 2017 at 05:11:17PM +0200, Krzysztof Kozlowski wrote:
> The Exynos4412 has the same watchdog as newer SoCs (e.g. Exynos5250).
> Just like the others, for working it requires additional steps in Power
> Management Unit: unmasking the reset request and enabling the system
> reset.  Without these additional steps in PMU, the watchdog will not be
> able to reset the system on expiration event.
> 
> Change the compatible of Exynos4412 watchdog device node to
> samsung,exynos5250-wdt which includes the additional PMU steps.
> 
> This will also fix infinite watchdog interrupt in soft mode (lack of
> interrupt clear) because it is also included in samsung,exynos5250-wdt.
> 
> Signed-off-by: Krzysztof Kozlowski <krzk at kernel.org>
> ---
>  arch/arm/boot/dts/exynos4.dtsi    |  9 ---------
>  arch/arm/boot/dts/exynos4210.dtsi |  9 +++++++++
>  arch/arm/boot/dts/exynos4412.dtsi | 10 ++++++++++
>  3 files changed, 19 insertions(+), 9 deletions(-)
> 
> diff --git a/arch/arm/boot/dts/exynos4.dtsi b/arch/arm/boot/dts/exynos4.dtsi
> index 18def1c774d5..71e2cdae6068 100644
> --- a/arch/arm/boot/dts/exynos4.dtsi
> +++ b/arch/arm/boot/dts/exynos4.dtsi
> @@ -283,15 +283,6 @@
>  		};
>  	};
>  
> -	watchdog: watchdog at 10060000 {
> -		compatible = "samsung,s3c2410-wdt";
> -		reg = <0x10060000 0x100>;
> -		interrupts = <GIC_SPI 43 IRQ_TYPE_LEVEL_HIGH>;
> -		clocks = <&clock CLK_WDT>;
> -		clock-names = "watchdog";
> -		status = "disabled";
> -	};
> -
>  	rtc: rtc at 10070000 {
>  		compatible = "samsung,s3c6410-rtc";
>  		reg = <0x10070000 0x100>;
> diff --git a/arch/arm/boot/dts/exynos4210.dtsi b/arch/arm/boot/dts/exynos4210.dtsi
> index f9408188f97f..e126357aba9a 100644
> --- a/arch/arm/boot/dts/exynos4210.dtsi
> +++ b/arch/arm/boot/dts/exynos4210.dtsi
> @@ -119,6 +119,15 @@
>  		};
>  	};
>  
> +	watchdog: watchdog at 10060000 {
> +		compatible = "samsung,s3c6410-wdt";

My mistake - here it should still remain at samsung,s3c2410-wdt because
I am just copying existing nodes to Exynso4210. The compatible should be
changed in patch 6/8.


Best regards,
Krzysztof