[PATCH v4 23/36] media: imx: Add MIPI CSI-2 Receiver subdev driver

[Steve Longerbeam]

On 02/17/2017 03:38 AM, Philipp Zabel wrote:
> On Fri, 2017-02-17 at 11:06 +0000, Russell King - ARM Linux wrote:
>> On Fri, Feb 17, 2017 at 11:47:59AM +0100, Philipp Zabel wrote:
>>> On Wed, 2017-02-15 at 18:19 -0800, Steve Longerbeam wrote:
>>>> +static void csi2_dphy_init(struct csi2_dev *csi2)
>>>> +{
>>>> +	/*
>>>> +	 * FIXME: 0x14 is derived from a fixed D-PHY reference
>>>> +	 * clock from the HSI_TX PLL, and a fixed target lane max
>>>> +	 * bandwidth of 300 Mbps. This value should be derived
>>>
>>> If the table in https://community.nxp.com/docs/DOC-94312 is correct,
>>> this should be 850 Mbps. Where does this 300 Mbps value come from?
>>
>> I thought you had some code to compute the correct value, although
>> I guess we've lost the ability to know how fast the sensor is going
>> to drive the link.
>
> I had code to calculate the number of needed lanes from the bit rate and
> link frequency. I did not actually change the D-PHY register value.
> And as you pointed out, calculating the number of lanes is not useful
> without input from the sensor driver, as some lane configurations might
> not be supported.
>
>> Note that the IMX219 currently drives the data lanes at 912Mbps almost
>> exclusively, as I've yet to finish working out how to derive the PLL
>> parameters.  (I have something that works, but it currently takes on
>> the order of 100k iterations to derive the parameters.  gcd() doesn't
>> help you in this instance.)
>
> The tc358743 also currently only implements a fixed rate (of 594 Mbps).

I've analyzed the OV5640 video modes, and they generate the following
"sysclk"'s in Mhz:

210
280
420
560
840

But I don't know whether this is equivalent to bit rate. Is it the same
as Mbps-per-lane? If so, this could be indicated to the sink by
implementing V4L2_CID_LINK_FREQ in the ov5640.c sensor driver.

The Mbps-per-lane value would then be link_freq * 2, and then
Mbps-per-lane could be used to lookup the correct "hsfreqsel"
value to program the D-PHY.

I've added this to imx6-mipi-csi2.c. If the source didn't implement
V4L2_CID_LINK_FREQ then it uses a default 849 Mbps-per-lane.


Steve