[PATCH 03/10] media: dt-bindings: vpif: extend the example with an output port

[Rob Herring]

On Tue, Feb 07, 2017 at 05:41:16PM +0100, Bartosz Golaszewski wrote:
> This makes the example more or less correspond with the da850-evm
> hardware setup.
> 
> Signed-off-by: Bartosz Golaszewski <bgolaszewski at baylibre.com>
> ---
>  .../devicetree/bindings/media/ti,da850-vpif.txt    | 35 ++++++++++++++++++----
>  1 file changed, 29 insertions(+), 6 deletions(-)

Spoke too soon...

> 
> diff --git a/Documentation/devicetree/bindings/media/ti,da850-vpif.txt b/Documentation/devicetree/bindings/media/ti,da850-vpif.txt
> index 9c7510b..543f6f3 100644
> --- a/Documentation/devicetree/bindings/media/ti,da850-vpif.txt
> +++ b/Documentation/devicetree/bindings/media/ti,da850-vpif.txt
> @@ -28,19 +28,27 @@ I2C-connected TVP5147 decoder:
>  		reg = <0x217000 0x1000>;
>  		interrupts = <92>;
>  
> -		port {
> -			vpif_ch0: endpoint at 0 {
> +		port at 0 {
> +			vpif_input_ch0: endpoint at 0 {
>  				reg = <0>;
>  				bus-width = <8>;
> -				remote-endpoint = <&composite>;
> +				remote-endpoint = <&composite_in>;
>  			};
>  
> -			vpif_ch1: endpoint at 1 {
> +			vpif_input_ch1: endpoint at 1 {
>  				reg = <1>;
>  				bus-width = <8>;
>  				data-shift = <8>;
>  			};
>  		};
> +
> +		port at 1 {

The binding doc says nothing about supporting a 2nd port. 


> +			vpif_output_ch0: endpoint at 0 {
> +				reg = <0>;

Don't need reg here.

> +				bus-width = <8>;
> +				remote-endpoint = <&composite_out>;
> +			};
> +		};
>  	};