[PATCH v13 06/12] usb: xhci: use bus->sysdev for DMA configuration
Alexander Sverdlin
alexander.sverdlin at nokia.com
Mon Feb 13 00:25:24 PST 2017
Hi!
On 11/02/17 02:27, Peter Chen wrote:
> For xhci-hcd platform device, all the DMA parameters are not
> configured properly, notably dma ops for dwc3 devices. So, set
> the dma for xhci from sysdev. sysdev is pointing to device that
> is known to the system firmware or hardware.
>
> Cc: Baolin Wang <baolin.wang at linaro.org>
> Cc: Vivek Gautam <vivek.gautam at codeaurora.org>
> Cc: Alexander Sverdlin <alexander.sverdlin at nokia.com>
> Cc: Mathias Nyman <mathias.nyman at linux.intel.com>
>
> Signed-off-by: Arnd Bergmann <arnd at arndb.de>
> Signed-off-by: Sriram Dash <sriram.dash at nxp.com>
> ---
> Hi, Baolin, Vivek and Alexander,
> I removed your tested-by tag due to add one change that adding sysdev
> for shared hcd too, if your test shows this change works for you or
> has no effect for you, please consider adding tested-by tag again,
> thanks.
This was exactly the missing/requiring part in your patch for my case.
I had to add it extra for the first test.
So, again, here is my
Tested-by: Alexander Sverdlin <alexander.sverdlin at nokia.com>
> drivers/usb/host/xhci-mem.c | 12 ++++++------
> drivers/usb/host/xhci-plat.c | 35 +++++++++++++++++++++++++++--------
> drivers/usb/host/xhci.c | 15 +++++++++++----
> 3 files changed, 44 insertions(+), 18 deletions(-)
>
> diff --git a/drivers/usb/host/xhci-mem.c b/drivers/usb/host/xhci-mem.c
> index ba1853f4..032a702 100644
> --- a/drivers/usb/host/xhci-mem.c
> +++ b/drivers/usb/host/xhci-mem.c
> @@ -586,7 +586,7 @@ static void xhci_free_stream_ctx(struct xhci_hcd *xhci,
> unsigned int num_stream_ctxs,
> struct xhci_stream_ctx *stream_ctx, dma_addr_t dma)
> {
> - struct device *dev = xhci_to_hcd(xhci)->self.controller;
> + struct device *dev = xhci_to_hcd(xhci)->self.sysdev;
> size_t size = sizeof(struct xhci_stream_ctx) * num_stream_ctxs;
>
> if (size > MEDIUM_STREAM_ARRAY_SIZE)
> @@ -614,7 +614,7 @@ static struct xhci_stream_ctx *xhci_alloc_stream_ctx(struct xhci_hcd *xhci,
> unsigned int num_stream_ctxs, dma_addr_t *dma,
> gfp_t mem_flags)
> {
> - struct device *dev = xhci_to_hcd(xhci)->self.controller;
> + struct device *dev = xhci_to_hcd(xhci)->self.sysdev;
> size_t size = sizeof(struct xhci_stream_ctx) * num_stream_ctxs;
>
> if (size > MEDIUM_STREAM_ARRAY_SIZE)
> @@ -1686,7 +1686,7 @@ void xhci_slot_copy(struct xhci_hcd *xhci,
> static int scratchpad_alloc(struct xhci_hcd *xhci, gfp_t flags)
> {
> int i;
> - struct device *dev = xhci_to_hcd(xhci)->self.controller;
> + struct device *dev = xhci_to_hcd(xhci)->self.sysdev;
> int num_sp = HCS_MAX_SCRATCHPAD(xhci->hcs_params2);
>
> xhci_dbg_trace(xhci, trace_xhci_dbg_init,
> @@ -1758,7 +1758,7 @@ static void scratchpad_free(struct xhci_hcd *xhci)
> {
> int num_sp;
> int i;
> - struct device *dev = xhci_to_hcd(xhci)->self.controller;
> + struct device *dev = xhci_to_hcd(xhci)->self.sysdev;
>
> if (!xhci->scratchpad)
> return;
> @@ -1831,7 +1831,7 @@ void xhci_free_command(struct xhci_hcd *xhci,
>
> void xhci_mem_cleanup(struct xhci_hcd *xhci)
> {
> - struct device *dev = xhci_to_hcd(xhci)->self.controller;
> + struct device *dev = xhci_to_hcd(xhci)->self.sysdev;
> int size;
> int i, j, num_ports;
>
> @@ -2373,7 +2373,7 @@ static int xhci_setup_port_arrays(struct xhci_hcd *xhci, gfp_t flags)
> int xhci_mem_init(struct xhci_hcd *xhci, gfp_t flags)
> {
> dma_addr_t dma;
> - struct device *dev = xhci_to_hcd(xhci)->self.controller;
> + struct device *dev = xhci_to_hcd(xhci)->self.sysdev;
> unsigned int val, val2;
> u64 val_64;
> struct xhci_segment *seg;
> diff --git a/drivers/usb/host/xhci-plat.c b/drivers/usb/host/xhci-plat.c
> index 6d33b42..4ecb3fd 100644
> --- a/drivers/usb/host/xhci-plat.c
> +++ b/drivers/usb/host/xhci-plat.c
> @@ -14,6 +14,7 @@
> #include <linux/clk.h>
> #include <linux/dma-mapping.h>
> #include <linux/module.h>
> +#include <linux/pci.h>
> #include <linux/of.h>
> #include <linux/platform_device.h>
> #include <linux/usb/phy.h>
> @@ -148,6 +149,7 @@ static int xhci_plat_probe(struct platform_device *pdev)
> {
> const struct of_device_id *match;
> const struct hc_driver *driver;
> + struct device *sysdev;
> struct xhci_hcd *xhci;
> struct resource *res;
> struct usb_hcd *hcd;
> @@ -164,22 +166,39 @@ static int xhci_plat_probe(struct platform_device *pdev)
> if (irq < 0)
> return -ENODEV;
>
> + /*
> + * sysdev must point to a device that is known to the system firmware
> + * or PCI hardware. We handle these three cases here:
> + * 1. xhci_plat comes from firmware
> + * 2. xhci_plat is child of a device from firmware (dwc3-plat)
> + * 3. xhci_plat is grandchild of a pci device (dwc3-pci)
> + */
> + sysdev = &pdev->dev;
> + if (sysdev->parent && !sysdev->of_node && sysdev->parent->of_node)
> + sysdev = sysdev->parent;
> +#ifdef CONFIG_PCI
> + else if (sysdev->parent && sysdev->parent->parent &&
> + sysdev->parent->parent->bus == &pci_bus_type)
> + sysdev = sysdev->parent->parent;
> +#endif
> +
> /* Try to set 64-bit DMA first */
> - if (!pdev->dev.dma_mask)
> + if (WARN_ON(!sysdev->dma_mask))
> /* Platform did not initialize dma_mask */
> - ret = dma_coerce_mask_and_coherent(&pdev->dev,
> + ret = dma_coerce_mask_and_coherent(sysdev,
> DMA_BIT_MASK(64));
> else
> - ret = dma_set_mask_and_coherent(&pdev->dev, DMA_BIT_MASK(64));
> + ret = dma_set_mask_and_coherent(sysdev, DMA_BIT_MASK(64));
>
> /* If seting 64-bit DMA mask fails, fall back to 32-bit DMA mask */
> if (ret) {
> - ret = dma_set_mask_and_coherent(&pdev->dev, DMA_BIT_MASK(32));
> + ret = dma_set_mask_and_coherent(sysdev, DMA_BIT_MASK(32));
> if (ret)
> return ret;
> }
>
> - hcd = usb_create_hcd(driver, &pdev->dev, dev_name(&pdev->dev));
> + hcd = __usb_create_hcd(driver, sysdev, &pdev->dev,
> + dev_name(&pdev->dev), NULL);
> if (!hcd)
> return -ENOMEM;
>
> @@ -222,20 +241,20 @@ static int xhci_plat_probe(struct platform_device *pdev)
>
> xhci->clk = clk;
> xhci->main_hcd = hcd;
> - xhci->shared_hcd = usb_create_shared_hcd(driver, &pdev->dev,
> + xhci->shared_hcd = __usb_create_hcd(driver, sysdev, &pdev->dev,
> dev_name(&pdev->dev), hcd);
> if (!xhci->shared_hcd) {
> ret = -ENOMEM;
> goto disable_clk;
> }
>
> - if (device_property_read_bool(&pdev->dev, "usb3-lpm-capable"))
> + if (device_property_read_bool(sysdev, "usb3-lpm-capable"))
> xhci->quirks |= XHCI_LPM_SUPPORT;
>
> if (device_property_read_bool(&pdev->dev, "quirk-broken-port-ped"))
> xhci->quirks |= XHCI_BROKEN_PORT_PED;
>
> - hcd->usb_phy = devm_usb_get_phy_by_phandle(&pdev->dev, "usb-phy", 0);
> + hcd->usb_phy = devm_usb_get_phy_by_phandle(sysdev, "usb-phy", 0);
> if (IS_ERR(hcd->usb_phy)) {
> ret = PTR_ERR(hcd->usb_phy);
> if (ret == -EPROBE_DEFER)
> diff --git a/drivers/usb/host/xhci.c b/drivers/usb/host/xhci.c
> index 6d6c460..ab0839c 100644
> --- a/drivers/usb/host/xhci.c
> +++ b/drivers/usb/host/xhci.c
> @@ -237,6 +237,9 @@ static int xhci_free_msi(struct xhci_hcd *xhci)
> static int xhci_setup_msi(struct xhci_hcd *xhci)
> {
> int ret;
> + /*
> + * TODO:Check with MSI Soc for sysdev
> + */
> struct pci_dev *pdev = to_pci_dev(xhci_to_hcd(xhci)->self.controller);
>
> ret = pci_enable_msi(pdev);
> @@ -263,7 +266,7 @@ static int xhci_setup_msi(struct xhci_hcd *xhci)
> */
> static void xhci_free_irq(struct xhci_hcd *xhci)
> {
> - struct pci_dev *pdev = to_pci_dev(xhci_to_hcd(xhci)->self.controller);
> + struct pci_dev *pdev = to_pci_dev(xhci_to_hcd(xhci)->self.sysdev);
> int ret;
>
> /* return if using legacy interrupt */
> @@ -748,7 +751,7 @@ void xhci_shutdown(struct usb_hcd *hcd)
> struct xhci_hcd *xhci = hcd_to_xhci(hcd);
>
> if (xhci->quirks & XHCI_SPURIOUS_REBOOT)
> - usb_disable_xhci_ports(to_pci_dev(hcd->self.controller));
> + usb_disable_xhci_ports(to_pci_dev(hcd->self.sysdev));
>
> spin_lock_irq(&xhci->lock);
> xhci_halt(xhci);
> @@ -765,7 +768,7 @@ void xhci_shutdown(struct usb_hcd *hcd)
>
> /* Yet another workaround for spurious wakeups at shutdown with HSW */
> if (xhci->quirks & XHCI_SPURIOUS_WAKEUP)
> - pci_set_power_state(to_pci_dev(hcd->self.controller), PCI_D3hot);
> + pci_set_power_state(to_pci_dev(hcd->self.sysdev), PCI_D3hot);
> }
>
> #ifdef CONFIG_PM
> @@ -4801,7 +4804,11 @@ int xhci_get_frame(struct usb_hcd *hcd)
> int xhci_gen_setup(struct usb_hcd *hcd, xhci_get_quirks_t get_quirks)
> {
> struct xhci_hcd *xhci;
> - struct device *dev = hcd->self.controller;
> + /*
> + * TODO: Check with DWC3 clients for sysdev according to
> + * quirks
> + */
> + struct device *dev = hcd->self.sysdev;
> int retval;
>
> /* Accept arbitrarily long scatter-gather lists */
--
Best regards,
Alexander Sverdlin.
More information about the linux-arm-kernel
mailing list