[PATCH v4 07/10] ARM: dts: STiH410-b2260: Identify the UART RTS line

[Lee Jones]

When hardware flow-control is disabled, manual toggling of the UART's
reset line (RTS) using userland applications (e.g. stty) is not
possible, since the ASC IP does not provide this functionality in the
same was as some other IPs do.  Thus, we have to do this manually.
This patch configures the UART RTS line as a GPIO for manipulation
within the UART driver when HW flow-control is not enabled.

Acked-by: Peter Griffin <peter.griffin at linaro.org>
Signed-off-by: Lee Jones <lee.jones at linaro.org>
---
 arch/arm/boot/dts/stih410-b2260.dts | 1 +
 1 file changed, 1 insertion(+)

diff --git a/arch/arm/boot/dts/stih410-b2260.dts b/arch/arm/boot/dts/stih410-b2260.dts
index 06b0696..fa16aba 100644
--- a/arch/arm/boot/dts/stih410-b2260.dts
+++ b/arch/arm/boot/dts/stih410-b2260.dts
@@ -63,6 +63,7 @@
 		uart0: serial at 9830000 {
 			label = "LS-UART0";
 			status = "okay";
+			rts-gpios = <&pio17 3 GPIO_ACTIVE_LOW>;
 		};
 
 		/* Low speed expansion connector */
-- 
2.9.3