[PATCH 07/25] arm: keystone: dts: Remove leading 0x and 0s from bindings notation

[Nishanth Menon]

On 12/15/2017 06:46 AM, Mathieu Malaterre wrote:
> Improve the DTS files by removing all the leading "0x" and zeros to fix the
> following dtc warnings:
> 
> Warning (unit_address_format): Node /XXX unit name should not have leading "0x"
> 
> and
> 
> Warning (unit_address_format): Node /XXX unit name should not have leading 0s
> 
> Converted using the following command:
> 
> find . -type f \( -iname *.dts -o -iname *.dtsi \) -exec sed -i -e "s/@\([0-9a-fA-FxX\.;:#]+\)\s*{/@\L\1 {/g" -e "s/@0x\(.*\) {/@\1 {/g" -e "s/@0+\(.*\) {/@\1 {/g" {} +^C
> 
> For simplicity, two sed expressions were used to solve each warnings separately.
> 
> To make the regex expression more robust a few other issues were resolved,
> namely setting unit-address to lower case, and adding a whitespace before the
> the opening curly brace:
> 
> https://elinux.org/Device_Tree_Linux#Linux_conventions
> 
> This will solve as a side effect warning:
> 
> Warning (simple_bus_reg): Node /XXX@<UPPER> simple-bus unit address format error, expected "<lower>"
> 
> This is a follow up to commit 4c9847b7375a ("dt-bindings: Remove leading 0x from bindings notation")
> 
> Reported-by: David Daney <ddaney at caviumnetworks.com>
> Suggested-by: Rob Herring <robh at kernel.org>
> Signed-off-by: Mathieu Malaterre <malat at debian.org>

Acked-by: Nishanth Menon <nm at ti.com>


-- 
Regards,
Nishanth Menon