[PATCH v3 2/2] arm64: dts: marvell: mcbin: enable more networking ports

[Antoine Tenart]

This patch enables the two GE/SFP ports. They are configured in 10GKR
mode by default. To do this the cpm_xdmio is enabled as well, and two
phy descriptions are added.

Signed-off-by: Antoine Tenart <antoine.tenart at free-electrons.com>
Tested-by: Marcin Wojtas <mw at semihalf.com>
---
 arch/arm64/boot/dts/marvell/armada-8040-mcbin.dts | 30 +++++++++++++++++++++++
 1 file changed, 30 insertions(+)

diff --git a/arch/arm64/boot/dts/marvell/armada-8040-mcbin.dts b/arch/arm64/boot/dts/marvell/armada-8040-mcbin.dts
index abd39d1c1739..9f0a00802452 100644
--- a/arch/arm64/boot/dts/marvell/armada-8040-mcbin.dts
+++ b/arch/arm64/boot/dts/marvell/armada-8040-mcbin.dts
@@ -127,6 +127,30 @@
 	};
 };
 
+&cpm_xmdio {
+	status = "okay";
+
+	phy0: ethernet-phy at 0 {
+		compatible = "ethernet-phy-ieee802.3-c45";
+		reg = <0>;
+	};
+
+	phy8: ethernet-phy at 8 {
+		compatible = "ethernet-phy-ieee802.3-c45";
+		reg = <8>;
+	};
+};
+
+&cpm_ethernet {
+	status = "okay";
+};
+
+&cpm_eth0 {
+	status = "okay";
+	phy = <&phy0>;
+	phy-mode = "10gbase-kr";
+};
+
 &cpm_sata0 {
 	/* CPM Lane 0 - U29 */
 	status = "okay";
@@ -154,6 +178,12 @@
 	status = "okay";
 };
 
+&cps_eth0 {
+	status = "okay";
+	phy = <&phy8>;
+	phy-mode = "10gbase-kr";
+};
+
 &cps_eth1 {
 	/* CPS Lane 0 - J5 (Gigabit RJ45) */
 	status = "okay";
-- 
2.13.5