[PATCH v2 1/2] Documentation: dt: add bindings for ti-cpufreq

[Dave Gerlach]

Rob,
On 09/07/2016 10:35 PM, Viresh Kumar wrote:
> On 07-09-16, 09:36, Dave Gerlach wrote:
>> On 09/07/2016 12:12 AM, Viresh Kumar wrote:
>>> On 31-08-16, 21:53, Dave Gerlach wrote:
>>>> +In 'operating-points-v2' table:
>>>> +- compatible: Should be
>>>> +	- 'operating-points-v2-ti-am3352-cpu' for am335x SoCs
>>>> +	- 'operating-points-v2-ti-am4372-cpu' for am43xx SoCs
>>>> +	- 'operating-points-v2-ti-dra7-cpu' for dra7xx/am57xx SoCs
>>>
>>> Why do you need SoC specific compatible here? Are you defining new
>>> fields in OPP tables for your SoC ? How are the tables for your case
>>> going to differ from the ones using "operating-points-v2" compatible
>>> string?
>>>
>>
>> I thought you had suggested that I do this in your comments from v1, but I
>> guess that was dependent on whether or not I put the properties I have
>> inserted into the cpu node into the operating-points table instead.
>
> Yes.
>
>> I still
>> have gotten no comments from any DT maintainers so I left it as is. I am
>> still not sure if that is acceptable.
>
> @Rob: Can you please share your views on the new properties being
> added to the CPU node ?
>

I am fine moving the properties in the operating-points-v2 node or 
leaving it as is, whichever is preferred.

Viresh, thanks for your comments.

Regards,
Dave