[PATCH] ARM: decompressor: reset ttbcr fields to use TTBR0 on ARMv7

Robin Murphy robin.murphy at arm.com
Mon Sep 12 10:51:54 PDT 2016


On 12/09/16 07:57, Srinivas Ramana wrote:
> If the bootloader uses the long descriptor format and jumps to
> kernel decompressor code, TTBCR may not be in a right state.
> Before enabling the MMU, it is required to clear the TTBCR.PD0
> field to use TTBR0 for translation table walks.
> 
> The 'commit dbece45894d3a ("ARM: 7501/1: decompressor:
> reset ttbcr for VMSA ARMv7 cores")' does the reset of TTBCR.N, but
> doesn't consider all the bits for the size of TTBCR.N.
> 
> Clear TTBCR.PD0 field and reset all the three bits of TTBCR.N to
> indicate the use of TTBR0 and the correct base address width.
> 
> Signed-off-by: Srinivas Ramana <sramana at codeaurora.org>
> ---
>  arch/arm/boot/compressed/head.S | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/arch/arm/boot/compressed/head.S b/arch/arm/boot/compressed/head.S
> index af11c2f8f3b7..fc6d541549a2 100644
> --- a/arch/arm/boot/compressed/head.S
> +++ b/arch/arm/boot/compressed/head.S
> @@ -779,7 +779,7 @@ __armv7_mmu_cache_on:
>  		orrne	r0, r0, #1		@ MMU enabled
>  		movne	r1, #0xfffffffd		@ domain 0 = client
>  		bic     r6, r6, #1 << 31        @ 32-bit translation system

Hmm, if TTBCR.EAE _was_ actually set...

> -		bic     r6, r6, #3 << 0         @ use only ttbr0
> +		bic     r6, r6, #(7 << 0) | (1 << 4)	@ use only ttbr0
>  		mcrne	p15, 0, r3, c2, c0, 0	@ load page table pointer
>  		mcrne	p15, 0, r1, c3, c0, 0	@ load domain access control
>  		mcrne   p15, 0, r6, c2, c0, 2   @ load ttb control

...then strictly the TLBIALL needs to happen after the ISB following
this update. Otherwise per B3.10.2 of DDI406C.c I think we might be into
unpredictable territory - i.e. if the TLB happens to treat long- and
short-descriptor entries differently then the TLBI beforehand (with EAE
set) may be at liberty to only discard long-descriptor entries and leave
bogus short-descriptor entries sitting around.

In other words, something like (completely untested):

---8<---
diff --git a/arch/arm/boot/compressed/head.S
b/arch/arm/boot/compressed/head.S
index af11c2f8f3b7..536b7781024a 100644
--- a/arch/arm/boot/compressed/head.S
+++ b/arch/arm/boot/compressed/head.S
@@ -764,7 +764,6 @@ __armv7_mmu_cache_on:
                mov     r0, #0
                mcr     p15, 0, r0, c7, c10, 4  @ drain write buffer
                tst     r11, #0xf               @ VMSA
-               mcrne   p15, 0, r0, c8, c7, 0   @ flush I,D TLBs
 #endif
                mrc     p15, 0, r0, c1, c0, 0   @ read control reg
                bic     r0, r0, #1 << 28        @ clear SCTLR.TRE
@@ -783,8 +782,11 @@ __armv7_mmu_cache_on:
                mcrne   p15, 0, r3, c2, c0, 0   @ load page table pointer
                mcrne   p15, 0, r1, c3, c0, 0   @ load domain access control
                mcrne   p15, 0, r6, c2, c0, 2   @ load ttb control
-#endif
                mcr     p15, 0, r0, c7, c5, 4   @ ISB
+               mcrne   p15, 0, r0, c8, c7, 0   @ flush I,D TLBs
+#else
+               mcr     p15, 0, r0, c7, c5, 4   @ ISB
+#endif
                mcr     p15, 0, r0, c1, c0, 0   @ load control register
                mrc     p15, 0, r0, c1, c0, 0   @ and read it back
---8<---

Robin.




More information about the linux-arm-kernel mailing list