[PATCH 2/2] ARM: bcm2835: Add names for the Raspberry Pi Zero GPIO lines

[Stefan Wahren]

> Eric Anholt <eric at anholt.net> hat am 15. November 2016 um 18:23 geschrieben:
> 
> 
> Stefan Wahren <stefan.wahren at i2se.com> writes:
> 
> > This adds the GPIO names for the Raspberry Pi Zero. Since there are no
> > schematics for the RPi Zero use the same as the Model A+.
> 
> These look good to me. I don't have a Zero schematic, but I compared to
> dt-blob.
> 
> I've pulled these two to -next.

Thanks. Unfortunately the link to the dt-blob is outdated. The newer ones [1]
contains the definition of the Raspberry Pi Zero and it differs from Model A+

Please drop the complete series and i'll send a V2. Sorry about this.

[1] - https://github.com/raspberrypi/firmware/blob/master/extra/dt-blob.dts

Stefan