[PATCH] input: bma150: Only claim to support the bma180 if the separate iio bma180 driver is not build

[Hans de Goede]

commit ef3714fdbc8d ("Input: bma150 - extend chip detection for bma180"),
adds bma180 chip-ids to the input bma150 driver, assuming that they are
100% compatible, but the bma180 is not compatible with the bma150 at all,
it has 14 bits resolution instead of 10, and it has quite different
control registers too.

Treating the bma180 as a bma150 wrt its data registers will just result
in throwing away the lowest 4 bits, which is not too bad. But the ctrl
registers are a different story. Things happen to just work but supporting
that certainly does not make treating the bma180 the same as the bma150
right.

Since some setups depend on the evdev interface the bma150 driver offers
on top of the bma180, we cannot simply remove the bma180 ids.

So this commit only removes the bma180 id when the bma180 iio driver,
which does treat the bma180 properly, is enabled.

Cc: Dr. H. Nikolaus Schaller <hns at goldelico.com>
Signed-off-by: Hans de Goede <hdegoede at redhat.com>
---
 drivers/input/misc/bma150.c | 8 +++++++-
 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/drivers/input/misc/bma150.c b/drivers/input/misc/bma150.c
index b0d4453..9fa1c9a 100644
--- a/drivers/input/misc/bma150.c
+++ b/drivers/input/misc/bma150.c
@@ -539,7 +539,11 @@ static int bma150_probe(struct i2c_client *client,
 	}
 
 	chip_id = i2c_smbus_read_byte_data(client, BMA150_CHIP_ID_REG);
-	if (chip_id != BMA150_CHIP_ID && chip_id != BMA180_CHIP_ID) {
+	if (chip_id != BMA150_CHIP_ID
+#ifndef CONFIG_BMA180
+	    && chip_id != BMA180_CHIP_ID
+#endif
+	    ) {
 		dev_err(&client->dev, "BMA150 chip id error: %d\n", chip_id);
 		return -EINVAL;
 	}
@@ -643,7 +647,9 @@ static UNIVERSAL_DEV_PM_OPS(bma150_pm, bma150_suspend, bma150_resume, NULL);
 
 static const struct i2c_device_id bma150_id[] = {
 	{ "bma150", 0 },
+#ifndef CONFIG_BMA180
 	{ "bma180", 0 },
+#endif
 	{ "smb380", 0 },
 	{ "bma023", 0 },
 	{ }
-- 
2.9.3