[PATCH 1/2] ahci: qoriq: added a condition to enable dma coherence

[Robin Murphy]

On 16/11/16 03:11, yuantian.tang at nxp.com wrote:
> From: Tang Yuantian <Yuantian.Tang at nxp.com>
> 
> Enable DMA coherence in SATA controller on condition that
> dma-coherent property exists in sata node in DTS.
> 
> Signed-off-by: Tang Yuantian <yuantian.tang at nxp.com>
> ---
>  drivers/ata/ahci_qoriq.c | 15 +++++++++++----
>  1 file changed, 11 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/ata/ahci_qoriq.c b/drivers/ata/ahci_qoriq.c
> index 9884c8c..45c88de 100644
> --- a/drivers/ata/ahci_qoriq.c
> +++ b/drivers/ata/ahci_qoriq.c
> @@ -59,6 +59,7 @@ struct ahci_qoriq_priv {
>  	struct ccsr_ahci *reg_base;
>  	enum ahci_qoriq_type type;
>  	void __iomem *ecc_addr;
> +	bool is_dmacoherent;
>  };
>  
>  static const struct of_device_id ahci_qoriq_of_match[] = {
> @@ -164,26 +165,31 @@ static int ahci_qoriq_phy_init(struct ahci_host_priv *hpriv)
>  		writel(LS1021A_PORT_PHY4, reg_base + PORT_PHY4);
>  		writel(LS1021A_PORT_PHY5, reg_base + PORT_PHY5);
>  		writel(AHCI_PORT_TRANS_CFG, reg_base + PORT_TRANS);
> -		writel(AHCI_PORT_AXICC_CFG, reg_base + LS1021A_AXICC_ADDR);
> +		if (qpriv->is_dmacoherent)
> +			writel(AHCI_PORT_AXICC_CFG,
> +					reg_base + LS1021A_AXICC_ADDR);
>  		break;
>  
>  	case AHCI_LS1043A:
>  		writel(AHCI_PORT_PHY_1_CFG, reg_base + PORT_PHY1);
>  		writel(AHCI_PORT_TRANS_CFG, reg_base + PORT_TRANS);
> -		writel(AHCI_PORT_AXICC_CFG, reg_base + PORT_AXICC);
> +		if (qpriv->is_dmacoherent)
> +			writel(AHCI_PORT_AXICC_CFG, reg_base + PORT_AXICC);
>  		break;
>  
>  	case AHCI_LS2080A:
>  		writel(AHCI_PORT_PHY_1_CFG, reg_base + PORT_PHY1);
>  		writel(AHCI_PORT_TRANS_CFG, reg_base + PORT_TRANS);
> -		writel(AHCI_PORT_AXICC_CFG, reg_base + PORT_AXICC);
> +		if (qpriv->is_dmacoherent)
> +			writel(AHCI_PORT_AXICC_CFG, reg_base + PORT_AXICC);
>  		break;
>  
>  	case AHCI_LS1046A:
>  		writel(LS1046A_SATA_ECC_DIS, qpriv->ecc_addr);
>  		writel(AHCI_PORT_PHY_1_CFG, reg_base + PORT_PHY1);
>  		writel(AHCI_PORT_TRANS_CFG, reg_base + PORT_TRANS);
> -		writel(AHCI_PORT_AXICC_CFG, reg_base + PORT_AXICC);
> +		if (qpriv->is_dmacoherent)
> +			writel(AHCI_PORT_AXICC_CFG, reg_base + PORT_AXICC);
>  		break;
>  	}
>  
> @@ -221,6 +227,7 @@ static int ahci_qoriq_probe(struct platform_device *pdev)
>  		if (IS_ERR(qoriq_priv->ecc_addr))
>  			return PTR_ERR(qoriq_priv->ecc_addr);
>  	}
> +	qoriq_priv->is_dmacoherent = of_property_read_bool(np, "dma-coherent");

Better to use of_dma_is_coherent(np) rather than open-coding it.

Robin.

>  
>  	rc = ahci_platform_enable_resources(hpriv);
>  	if (rc)
>